Recent content by mlongboat

Masters kit is in 727 and just waiting for stall. Thanks for the answer calrobb2000

This is for 68 Dart GT conv, car will be used for street and highway.

Will a Torque converter with a stall Range of 2400 to 2800 work well with a purple shaft 474 lift cam that has a basic operating range of 2000 to 6000. 355 gears. The motor is a 340 with 10.5 to 1 pistons with 2.02 int valves and 1.60 exh valves X heads. And 14 inch rims. This is for 68 Dart...

Do you have one for sale.

Looking for any used top boot retainer +

Would you have a extra top boot retainer?

Got it. So now looking for any Dodge, Plymouth, Chrysler top boot retainer. I hope this ill work Herb's Parts: 70-71 E BODY CONV BACK SEAT BOOT RETAINER, Convertible Parts, 299-ST

1968 Dart GT. this retainer has 9 holes for it to be screwed on back of seat. for other models the part numbers are different except for the Barracuda. It has same part number as the Dart. But if there is another model that wiil fit let me know please.

This part is attached to rear seat and retains top boot for a convertible.

need complete set

Hello was wondering if you still had gts fender templates? If so a copy of holes would be needed, would this be available?

Sitting same place as mine, with original mounts.

Had no problems, installing them in 68 dart. Drivers side points down more at crossmember, than passengers side. There is difference in height. Passengers is closer to crossmember. But it does clear.

the upper plug beside cam was not installed, 80 psi while priming. :finga: it will be dancing tomorrow. Thanks for input.