Recent content by nitrohemi

Lower control arms with new pivots. $200 plus the ride or pickup Lancaster pa

I have some 13/16 and one 5/8 hemi sparkplug t handles. Hemi spark plug t handle wrench | eBay. I have them listed on ebay but will sell direct to avoid the ebay fees. $25.00 plus shipping.

383 pushrods for solid lifters. 8.600 long. ball on one end cup on the other. They are from Mancini racing. Used for mock up. $132 new. $60.00 plus shipping.

I have new sway bar bushings and bump stops. Tie rod sleeves also included They are new in the box and have been sitting on my shelf for a few years. What you see is what you get. $60.00 plus shipping from Lancaster PA

Autometer pro control. I have had this for years. Was going to use this for nitrous control at one point. $25.00 plus shipping

10 inch drums and spindles. Upper small ball joint control arms. Brakes and drums look good. $60 obo. Would prefer pick up in lancaster PA

That was my thinking also.

couldn't get a roller cam I liked so switched to flat tappet.

I am currently running a stock 5.2 magnum in a D150. Headers, Carb, Port matched. Just finished building a 318 with XE262 Cam. Stock 89 short block, port matched. Do you guys think the 318 with the XE262 cam will make more noticeable power compared to the stock 5.2?

Does anyone reproduce these clips. They are behind the rear interior trim at the back glass on a fastback. What other years use this? Thanks.

I do not have the pan. I made a front sump pan for a setup I am using. Keeping it and reworking it for a different setup.

Milidon dual pickup external oil system. includes the plate thea goes between the oil pump and block, plate that goes on top of the oil pump for the filter, swinging oil pan pickup, hoses and caps incase you only use one pick up, and longer distributer drive shaft for a 383/400 block. You...

Moroso underdrive crank pulley. Bolts included. $40.00 plus the ride

I have a Sun 500 machine. I have heard there is a way to hook up a GM HEI module to do electronic distributers. Does it work and how is it done. I do have the LED kit from armount installed and it works awesome for doing points.

What upper a arms are you using for the suspension?