Recent content by nutz

woudn't run it without the balancer could end up cracking your crank just cause it hasn't yet you need to tie together the frame rails where the old org bell housing trans mount were when they moved the rear trans mount think they make a kit ...something about the flex in the rear spring...

Nice I had to build one of those years ago

I was thinking where the bell housing bracket Was by the starter

20years that's a 03 till 05 passat

Yeah it was nice cause my taxes aren't bad Waiting till they re assess it

yeah been collecting ho...i have a hard enough time seeing that

rust is still on the inside ...they rust from the inner foam nice for a flip ...give it a winter

what about glueing it old man i know my body guy glues rocks/quarter on so you don't expose raw steel not the way ma mopar did it but the latest and greatest way

lot of small block chevys are down by the crank..... that looks like a bosch sensor make sure the wires are shielded high voltage will f-with those

don't think stainless likes anything to stick to it and too hot it might get brittle not 100 % sure of the fitment ..but maybe garage door cable come with the crimps

I would say my previous owner depreciated my shop It was a dump....200k later and just a little less then a dump

The stupid stainless steel capped lugs They swell up what a pia My fav are porsche titanium lugs Feel like plastic

Shhhhhh of course......

Yes good point I do 1/4 payments ....hurts less Or open a tax account so you can collect interest before you give your blood and sweat

its even harder to do it right after it was done wrong