Recent content by outboardguy

Hi..I'm putting a 2006 5.7 hemi out of a charger, into the old car. Donor car has a nag1 trans, which apparently is almost impossible to make work without spending less than a million dollars. Can I put a 45rfe or 545rfe behind it and change the ecm with my hp tuners to mske it work?

Hello...I am in the planning process of putting a 2006 5.7 hemi in my 67 charger (I also have a 69 barracuda and don't feel like joining the bbodies only group). Anyway, my donor car has the nag1 trans, and as much as I'd like to use it, it seems like a ridiculous amount of work to get to...

I have a brand new set of wheel adapters that I'll never use because I found proper small bolt pattern wheels..these go from small bolt pattern and make them large bolt pattern...they are an inch thick .... Located near Belleville, Ontario Canada...$125 Canadian

I dont know how to pm anyone on here....lol....how much are the left hand thread wheel studs for the Kelsey hayes disc brake setup?

Thanx for the response....it does seem like I'm going to have to go to right hand thread studs....I JUST purchased the left hand lug bits for my old school slit rims and was trying to avoid buying nore right hand lug nuts when I finally go to switch to my Kelsey hayes disc brake setup (it's...

I'm sort of hoping to not spend 100US dollars on 5 lug nuts...to me as a Canadian that's like 150$.....Thanx for the reply though

Hi....if theyre from a rear axle, they won't work....the Kelsey hayes ones are weird....I can't figure out how to post pictures, but the shank is about .550 inches in diameter from where the threads start, and are 3/4" inch long then they step up to .575" for about a 1/4" until they hit the back...

I am still in need...5 of rhem ....how much are you asking for them?

Hi...I need 5 left hand thread ones...but for the Kelsey hayes disc setup...they are quite a bit longer than a rear axle one....how many do you have and are they from the disc brake setup?

I am looking for 5 wheel studs for the Kelsey Hayes Disc setup...mine are 7/16" studs, and are LEFT HAND THREAD...I cant find any here in Belleville Ontario, Canada....I could also use 2 of the right hand thread type...If anyone has any, or knows where to get some, please let me know. Thanx

I quickly tried a heat gun, but no change.....I can live with it, but my next one will be better...my point was ...the Legendary seat covers are awesome!...That is the first time ive ever tried a car seat recover job...good product and worth the few extra dollars

The sun....good tip.....oh, to see the sun for a few days in a row...lol....

Hers a picture of the done seat...it isnt perfect, but if you look at what I started with, its way better...I learned a bit, and the next seat will have none of the wrinkles..I pulled the centre part of the cover too far down, which is what caused the ripples

I just installed my first ever seat cover on a car...I bought the Legendary seat covers...All I can say is either I missed my calling as a seat recover-er, or the Legendary product is fantastic....went on like pie.....10 Thumbs Up!!!!

Thanx for responding....I oredered 2 types...soffseal is one and the other I ordered from National Moparts in Canada...they're both the same...the thread you posted about weatherstrip is helpful for sure....I've always done Chev's(I know...kill me now...lol) and they usually go into the U part...