Recent content by Owen Diaz

Looking for small block trick flow heads to finish my build

Thank you

Could I still use a flat tappet cam and lifters with this block?

Yes it was La roller cam my bad I got it confused

So I previously had a hydraulic flat tappet 360 La block with a mopar purple cam (which i want to re use) now I have a 89 360 La roller cam block I was hoping to use that same cam with trick flow heads and 1.6 ratio Mancini rockers just wanted to know if I would have to get special pushrods/...

Just to make sure I’m right you’re talking about these correct?

I’m trying to make a street/strip build had another 360 with eagle rods and KB flat top pistons I think that was .30over and one of the rod bolts broke on me so I decided to buy a block from someone who had stock rods and crank and I just need the pistons to finish the rotating assembly

Lol yea I think 12-1 compression would be too much

Would I have to call for them to make it for me or would I be able to order them right on summit?

Not sure if the chamber size all I know is there J heads do have pictures of the numbers in the head

Looking for some Suggestions on what I should go with plan on using stock crank/rods flat tappet cams/lifters and J heads As far as in stock options go this is what I see available on summit IC745.060 KB356.060 KB107.060 IC9978.060 KB362.060 Also want to add I plan on getting the rods shot...

Wouldn't it be more cost effective to stick with the flat tappet set up and just swap everything to the 89 block?

Yea I was told they were J heads, quick question if I want to use the hydraulic roller set up would I have to get new heads

Hopefully one of these is the right number so I don’t look like a complete idiot

Yes and I have lifters and a stock cam shaft which if I went with the hydraulic roller set up I’d probably change to something similar I had on my flat tappet set up