Recent content by Peedeeguard

I live in Hamlet. I have never encountered anything like this before so it has me a little baffled. Good luck with your Dart.

I will check the vent tube to see if it is clogged. It leaked out of my cap too. So can I get another seal for the fuel door or do I have to replace the whole unit? Also, is this a common occurrence on this make and model? Thank you for your help. I really appreciate it.

I had just filled up but, when I drove it back home I had zero spillage. After I got home I replaced the old trunk weatherstripping and never had the hint of gas. Thank you for the reply.

So, I thought I was finished with my 68 Barracuda but, out pops another problem. The car was sitting on level ground and when I went out to take it for a drive I smelled gas. I opened the fuel door and saw that gas has traveled up the pipe and ran out thru the fuel door. Is this a common...

After a couple of failed attempts to install the front bumper on my 68 Barracuda I decided to RTFF and found this thread. Now the bumper is on perfect and I didn't have to unload a 30 round magazine of 223/556 into the car out of frustration. Thank y'all. This forum has been a great lifeline.

My 68 Cuda is finally painted and for me to install trim, emblems and bumpers. Took me 2 1/2 years to restore but, well worth the effort.

Really? I never thought I would see a day when a part for my Barracuda would cost just $1.66. Thank y'all for your help. I searched all over the internet for a rear license plate bracket. Boy do I feel like an idiot. LOL

Thank you. I could not find and answer anywhere.

Thanks

Thank you

You said it brother.

I have finally gotten my 68 Barracuda restored and ready to put it on the road. But, I cannot find a rear license plate bracket for it. As a matter of fact I cannot find a picture of what one looks like. Most of the pictures I have seen are of the front bracket. Is the rear bracket the same as...

If anyone has the bottom two pieces I will buy those.

PM sent

Coupe. Thank you.