Recent content by Peini

Let me do the research: where are you located?

I am looking for a SBM distributor hold down clamp for a 340 from 1968 incl. shipping to Austria/ Europe. Thanks Chris

Did as described some minutes ago and worked great. Thx Chris

Yes the balancer was on before I tightened the timing cover and I used the tool to install the dampener.

:rofl:

Hi guys, I rebuilt my engine, a 340 small block for my Dodge Dart, and thought it might be easier to tighten the harmonic balancer to spec with the engine in the car and put it in gear since I have a 4spd manual transmission. Now that the engine is in and this is one of the last to dos before...

Although gas prices are quite high this is not my concern and the reason. I just like the look of it to be honest and would like to go with this rusty, dented piece.

Great idea, thanks a lot! Again: great idea! Now that I know that it is a Stant locking cap I will check. Thanks! Might be but I will try to get a new grommet first.

Dear all, I am looking for a fuel cap grommet NOT the gas filler tube grommet at the tank but the one on the inside of the gas cap. Attached some pictures. Any hint where to find that grommet? I searched the internet and the forum already but without any success. Thx Chris

Thanks cudamark! And regarding diameter difference? 5/16 to 0.28

Hi all, I am completely lost and really need your help with my push rods for my 1968 Dart with 340 engine. Based on what I read so far, I thought original push rod size is 7,5 inch long and 5/16 diamater. In this FABO thread 340 push rod length dibbons mentions the correct size with 7.534 and...

Dear Mopar-friends, I am looking for one single front wheel hub for my 1968 Dodge Dart with 10 inch drum brakes. Wheel studs do not need to be good. Unfortunately someone messed around with my wheel hub so the original stud size does not fit any longer. I am located in Austria/ Europe so...

I am looking for the early style timing chain cover with the bolt on style timing indicator on the pass side for my 1968 340. Thanks! Chris

Thanks a lot- I already saw you post during my search here on FABO. It would be great if you could check if you have some left and let me know. But please keep in mind that I want new ones- the old ones I have myself. Happy holiday!

Thanks guys!