RealWing

Profile posts Latest activity Postings Post Areas About

  • On Passon's 5 speed, do you know what that brass plug is on the top driver side of the trans is? Assuming the fill plug is that bigger plug in the middle of the passenger side main case...
    RealWing
    RealWing
    That is the vent
    RealWing
    RealWing
    Yes, the fill plug is in the middle of pass side
    RealWing
    RealWing
    The drain plug should be stamped "DRAIN". Dont unscrew any other plugs on drivers side!!!!
    So if the switch is laying on a forty degree workbench it should be closed I would guess, right?
    RealWing
    RealWing
    Probably. As the temp drops below approximately 40F, the switch should open. I say approximately, because each switch may be slightly different. They are not precision instruments!!!
    Jim
    What fit issues did you come across, putting a gen 3 hemi in your barracuda? Was thinking of doing the same, because I came across a good deal on gen 3 hemi from a dealership. Currently I am building a 67 fastback barracuda. Just ordered a new k member from HDK, got to make up my mind quick,because I was originally going to use a 440.
    RealWing
    RealWing
    There were major no fit issues on my build mainly because I got rid of the stock K frame and used the RMS front suspension package. I did have to move the steering column over slightly to clear the headers.
    Jim
  • Loading…
  • Loading…
  • Loading…
  • Loading…
Top