Recent content by rgrella

UPDATE: Strange shortened axles by .250" and they fit perfectly!

The attached file show the break out of the lockers, on the tab "Soft locker" look at items 13 & 14, these are plates i'm referencing. They are also found in the NoSpin configurations for purchase at Summit etc.. They are suppose to reduce the "banging" had to upload pictures, excel will not load

UPDATE: the axles are too long, been on the phone with Strange and working through all the calulations and we come to find that in the detroit lockers (Soft locker) there are dampering plates that limit the axles ability to slide into the carriage to far. When the axles are installed they go...

have a question, i just received my axles from Strange and noticed that the invoice shows both left and right axles to be the same length, sure enough they are the same. Am i crazy but i thought there is a left and right for dana 60 axles. The rear was cut and measured, Drivers side tube (flange...

I think i found my problem, after talking to Yukon and reading your reply i removed the ring gear to locate the part number on the locker. While the person i bought it from stated it was for 4:10 and lower the locker is actually for 4:56 and higher. Since i purchased it several months ago i'm...

Let me first lay out what i have then discuss the problem: 1- Dana 60 housing, shorten and bear (no axles etc.) 2- Yukon kit: yk-D60-R 14037 3- Ring and pinion: 4:10 (5-01-91 Dana D 30360 PAL154 41-10 When setting the pinion into the housing i'm unable to achieve the pinion depth of 3.125. I...

On the 15x10 and 15x12 rims, what size tire did you mount, how tall and how wide. thanks Ray