Recent content by rod locker

Sorry....It is located Tennessee. Put it in the ad also. Thanks..

1974 Duster, 318, Auto, 2.71 rear end, new upholstery, new carpet, Blaster II coil, Mopar valve covers, and air breather, lemon twist wtih matching mounted tool box and bumper jack. Odometer shows 66,800 miles. Ususally drive it once a week or on weekends. Asking $8500 OBO. Please PM for...

Sorry guys. I have a '74 Duster with a 318. And the fuel gauge along with the other gauges work fine. I have had the car now 3 years and it just started this all of a sudden.

I have changed upper and lower radiator hoses, thermostat, and added fresh coolant. I have looked inside radiator and seen the coolant moving so the water pump is working. However, as soon as I starti up the temp gauge goes dirctly to 250 degrees. How does the gauge get its signal? Where is...

Wondering it there was an advantage of either Sea Foam or Sta-bil your car, boat, motorcycle, and/or lawn mowers. Does anyone else use them? Worried aoubt the ehenol content of gas and the damage it can cause.

Does it matter? I have been told mount it vertical to allow it to cool properly because of being oil filled. However, the stock coil on my 318 is laying down. Does it matter?

Looking at Taylor's Spiral Pro wires with a 90 degree boot. It is very tight fit on a couple of plugs with OEM exhaust manifold and straight boots on 318. Is this a good choice of wire set?

Needing wires with a 45 or 90 degree boot. I have straight boots on now and on the driver side they are realy hafd to connect because of the exhaust manifold. Looking also to change out plugs. What combo do ya'll run in a '74 318 with a 4 barrel. Will also be changing manifold to Performer...

Love the look and stance of these racers.....just wondering what are the requirements for a drag car to be classified as a gasser? Thanks...........

Wondering where I can get a good tool that pushes the pistons back into place? It is for a 74 Duster......Just want one that works well and not overly expensive. Thanks...............

I have a slight shimmer in the front end I can feel in the steering wheel whenever I apply the brakes. I have disc on the front and drum on the back in a '74 Duster. Can any one give me some direction of where to look? This is the only time I notice the shimmer. Thanks again guys !!!!

Thought I would call MSD and get their opinion on this subject. I was told by MSD that the coil (blaster 2) could be mounted either horizontally or vertically with stock ignition. However,with a MSD ignition he told me to mount it vertically because the MSD ignition would cause more heat in...

Needing to change the shocks on all 4 corners on my 74 Duster. Do not want coil overs......just some good riding shocks that bolt right in. What do ya'll recommend? Thanks...............

Gee.......now I am all confused. My 318 has a new ballast resistor and ignition module.....and everything else electically is stock. I changed those just because. I haven't looked but am pretty sure car still has points. It is a 1974 model Duster. Haven't had the car long and was going to...

Looking to replace stock coil in 1974 318 with a MSD Blaster 2. Everything else will remain the same for now. Are there any problems that I may run into with this swap? Should be pretty straight forward.