Recent content by rod440

Thanks fellas!

Can someone tell me if the upper & lower stainless trim on my standard '71 Duster grille will fit on the OER 340 "sharktooth" reproduction grille? Thanks! Rod in Wi.

I see that Dante's Mopar parts offers a fiberboard 2 piece headliner for '72 & up Dusters.He also sells the plastic replacements.Just wondering if anyone has seen or installed one of these new fiberboard replacements & if so,how is the fit & finish compared to the plastic headliner?

My '72 Duster was built with a 3 speed stick that I replaced with a 4 speed.I also added the reverse light on the dash. My question is where or how did the factory connect the dash light to the harness? Thanks!

If you decide to do it yourself I would highly recommend Tom Hand's (VOETOM on this site) guide book for servicing Tourqeflites.

I would like to buy a new fuel filler pipe for my '72 Duster but can only find one for '70 / '71 with ECS or '73 / '74 with folding rear seat,or for '75 / '76. Can any of these be made to work on a '72? What changes were made between these years?

Make sure the fuel pump push rod isn't worn...

Here is a link to a thread with more info on this car. It was started by the guy that I bought the car from. 1966 Plymouth Valiant 100 Ken's 66 Valiant has Subframe Connectors!

Mike, If you use the driveshaft code from your broadcast sheet & Galen's vol I book it will tell you the ring gear size that was installed at the factory.

I'm looking for help decoding the broadcast sheet for a '66 Valiant 100. It's a 273 Commando/4 speed / 3:91 SG 8 3/4. No radio,heater delete,seat belt delete. There is no factory seam sealer or sound deadener. I'm pretty sure this car was special ordered for drag racing,although it was never...

I have a '66 V-100 with an 8 3/4 3.91 SG that looks to have been there from day one. The build code for the axle is 173,I can't find a reference for that # in the white book,but the 41 code for the pinion would seem to be correct for the ratio. I will start a new thread on this car & ask for...

I am looking for the Mopar part # for the front license plate bracket for my '73 Duster...the parts list I used doesn't show it (or I couldn't find it).My car did have the bracket on it at one time but it went MIA...if I had the part # I could try a search. Thanks! Rod in Wi.

I need a front license plate bracket for a '73 Duster,needs to be rust/pit free.Thanks! Rod in Wi.

I'm looking to buy one 440 emblem like the one pictured,NOS or nice used,must be OEM Mopar. Would also be interested in a pair of "440 FOUR BARREL" emblems.Thanks! Rod in Wi.

Two years ago I picked this up in LA & drove it to the the top of Nova Scotia,then back to Wi. Last year the wife & I drove it Fogo Island Newfoundland.I also use it as my daily driver in the summer.It still has points & drum brakes!