Recent content by Samsquanch

Hey everybody hows it going? Happy Moparing to you. My question is, can I use my 450 cfm four barrel for my enitial start up and break in? the 450 is way undersized for what I need after the fact and I'm trying to trade a 650 summit DP and this Edelbrock 450 AVS2 for about a 750 cfm DP over on...

Hey everybody hows it going? I'm looking to trade two good Carbs just undersized for what I need. 1 is a Summit 650 cfm carb double pumper and the other is a Edelbrock 450 cfm AVS2 carb both electric choke both work I need about 750 cfm electric choke double pumper please. Thank you

Did you find and insert alignment dowel pins? If not I'd start there and then get new head gaskets, fel pro are fine so you don't waste another expensive set in case that's not the problem and ARP says you can re use their bolts as long as they weren't over stretched

great idea

Thats what I'm looking for. Didnt know they even existed. Thank you very much

Hey my mopar brethren and sistren, is that a word? Anyhow, I need to know how to support an engine (360 magnum) in the engine compartment (1968 Barracuda fastback) without the transmission mounted up and still be able to roll the car back and forth. It might be a while before I get the new...

He's still open, I just put out $4800 bucks including $550 shipping for an 8 3/4 with sure track and a couple other upgrades to replace the turd 7 1/4 one wheel squealer I have now. Seemed like a lot to pay but got tired of looking and dealing with craigslist and FB marketplace A holes. Guy's...

ouch, that is a long way.

It's hard to trust what your getting from junk yard blocks or private seller blocks, the person could be trying to recoup money they lost on a bad purchase and stick me with the loss, I got lucky once already and the guy is giving me back my money. just safer to do it with a guarantee backing it...

True.

That's been the story of my life so far, but when you have no choice but to drive then a drivin I will be a doin lol your guy must be in Carolina?

I thought about that but it will be stored in a climate controlled garage wouldn't it be better to have it ready for installation if needed?

Hey fellow virginian, have you noticed machine shops are getting scarce? I cant find anyone within a 2 hour drive who will just dunk a block for me. I want to pull out this #'s matching 318 and recondition it and put it aside for if I ever sell this thing or get tired of romping around in a...