Hahaha, just realized I wrote driver side, but definitely need the passenger side. I laugh because I always mess up my right from left so I made sure I had that part right lol
Dave got back to me from Laysons and said they don't have this piece available. He also said the skins are not being...
Hi Mike, thanks for the reply. I did look at their catalog and they only list a patch for behind the wheel. I just sent them an email to see if they have any ideas where I could find this.
Looking for a patch panel to go in front of rear tire for the drivers side (RH). I purchased one for the left side years ago from Auto Body Specialties, but they no longer offer these. All I can find online is the entire skin. I am hoping that there is someone out there that has one kicking...
Looking for these braces that go between the front frame rail and rocker panel. Also could use some pieces of the torsion bar cross member. Need to repair some cutouts used for fender well headers.
upload_2020-5-22_14-40-19 by shakedownscott, on Flickr
splash sheild by shakedownscott, on Flickr
Hello,
Looking for these plates that are between the front frame rail and inner rocker panel. The ones on my barracuda project were cut and smashed in for fender well headers. Need both sides, hoping not to have to fix these :) Also could use the piece of the firewall where these attach...
As others have said the temperature and amount of hardener will both effect cure time. Its just going to take some experimenting and practice.
I have done some fiberglass boat work. When you are laying up big sheets of fiber glass, hardening too soon can ruin your day. It uses the same...
Thanks for looking Mike, I appreciate it.
Your ride is looking great. Love the color,it goes really well with the white top. Are you going to add the stripes back?
The fish that I am looking for is about 3-5/8" long, with 1-1/2" pin spacing. Pretty sure that is the correct one for a '69. The car I have came with no fish or holes for them, was re-badged as an "S" by the PO.