started with this
318 with 360 heads mild cam, holly 650 /904 tran
http://vid1357.photobucket.com/albums/q760/silvadful/318 eng/New Project 1_zpsz4um43ps.mp4
had a rebuild thread on nz mopar forum but that site shut down so started this one, hope its in the...
will ad some stuff after work, started on this cpl years back just getting to the good bits of gapping panels and body filler etc
this is what im aiming for, far from here at moment
degreed my cam a while ago and this link was the best / clearest info i could find.
pretty easy just your take time and when ya think youve got it right go thru it again and check result. takes all the guess work out of it.
http://www.lunatipower.com/Tech/Cams/HowToDegreeACam.aspx.
when ya take out windsheild and fix the rust it may be worth doing this. no more blocked up drain holes.
crap always gets stuck in small original hole, gets wet and sits there creating rust.:banghead:
heres mine. it out side so no room lost. just an old packing crate. bit o ply
for door. perspex window an cpl old sheets roofing keep the water out.
some old wet weather pants put your arms through and
at standing height no bending over looking down. still need lights an vacum. gets hard to...
how do you raise and lower it. just made one very similar but havnt put car on yet? still have to make centre brace from post to post . hopefully this weeknd
hey krazy. yeh a diagram of where the heater/bypass and what ever else hooks up to it .and what they for. cheers.
lol just read your post again. missed that bottom bit. think that all i need but a pic be sweet. thanks
and hebrews yes could run much more but this aint a race car. just a...
here a few pics o motor an bits so far
318 0.20 over /360 heads mild clean up.
remove casting flash etc 3 angle valve job
forged crank
comp 9.5.1
kb399 pistons zero deck
comp cams 260h
318 rods arp bolts
stock cast inlet rebuilt 600 holley ??
upgrade to alloy later
stock 360 ex man.
will...