Recent content by Skezix

Ya I bag everything in a restoration, printed labels with corresponding pg numbers to the assembly manual(s). If I restore something its frame off all bolts wheeled/treated replaced if needed. I have a spot where I put things if I get interrupted or have to leave in a hurry generally to come...

Similar but the metal is actually the bushing, the rubber is inside with the two little plastic bushings that slide into the rubber..

Heh.. exactly.. Yet apparently not for the demon I am working on, it must have been something previous and I ended up machining something to work as this sat there. Diameter is smaller than the A body linkage pin that comes up from the transmission.. No clue.. it will go back into my "dont lose...

Well its been over a year, this was placed in my "dont lose ever" spot.. I have been looking at it for ever it seems and today I went to connect my shifter linkage thinking forever now that this must have been the parts.. Obviously not after I picked it up. Anyone have a clue or has this been...

100$

These came off a 71 Duster, the right one appears to have been "fixed" area flattened out and some trimming off the top. They still fit well and did their job.. I had them blasted and powdercoated black and I applied raptor on the outside. There is some shelf dust from sitting, have not been...

I rebuilt this with intention of using it in a 71 Demon. I used two boxes to build one. It is not perfect but very nice. It was totally disassembled cleaned, I coated the inside for smoother air flow. New gasket kit/vent door foams/seals.. New heater core.. Comes with the Jhook, cables...

Ahh I missed that this did not come with fac tac so I was not even looking there, the wire being there caught me off guard.. today they wire for every acc and only use some.. Not use to seeing that in the past. Thanks so much everyone.

Eyes are crossed from looking at my diagrams and either they are hiding from me or not there.. Dark blue comes directly out of the fuse panel, appears it heats up something on the back of the rally dash?? It was disassembled to long ago I cannot remember. It is also factory tied to a gray/bk...

300$ Shipped

175$ Shipped

I rebuilt this with intention of using it in a 71 Demon. I used two boxes to build one. It is not perfect but very nice. It was totally disassembled cleaned, I coated the inside for smoother air flow. New gasket kit/vent door foams/seals.. New heater core.. Comes with the Jhook, cables...

These came off a 71 Duster, the right one appears to have been "fixed" area flattened out and some trimming off the top. They still fit well and did their job.. I had them blasted and powdercoated black and I applied raptor on the outside. There is some shelf dust from sitting, have not been...

Ahh thanks Blu, thats about right where I am riding atm.. so the height is not going to be an issue. I will have to play with the drop I get at the bottom rear of the door as I cannot stay with the 1/8 gap I have between the door and the cowl, its just not enough.

Yes the 1/8 is my issue.. If I attempt to pull it out anymore than that the bottom door sinks to far into the jam for me to massage it out, once I clean up the lead area/prime/paint that 1/8 will be even smaller. I may have to play with the bottom of the door.. I do not use much in the way of...