Recent content by skizzo

I vote minor relevance in the scope of all things. Either/or.

Good job, MH, looks fantastic. As far as mounting that Summit pump, lol just make sures its isolated from the body or you wont be able to hear anything other than that f’n pump!

That. Way small. Not right even a little. You shouldn't be eye stinging rich ootb with those carbs. Are y'all positive your pv's are closing? Dribbling boosters, sticky butterflies,, etc? And as has been mentioned, timing.

Just tee into your co2/argon line and backpurge the tank while you weld. Dont be using water with arc welders fellas.:-)

How about a smaller idler pulley on the tensioner?

Dude there is a bushing/collar that goes on first, like a crush sleeve. Cant tell if its on in the pic, but that can cause exactly the issue you're having if its not torqued.

Throw a shitload of fuel and timing at it.

Go to LUP, ive pulled many from there. Under $300 otd with a 24,000 mile warranty or something lol. And they're super cool. They'll fork that junk over to the loadout for you unlike a lot of places here that make you push a sketchy 15 foot high gantry that weighs about 600 lbs on its own...

Vacuum leak. Did you use the cork/end seals or RTV on the intake?

The 750 slayer is dual feed homie, just not a double pumper, vac sec.

Plug that middle emulsion port. Move ifr to below fuel (easy tap job, google). 4 hole spacer, not just a gasket. Dont get all cray-cray on the bleeds, small changes. Make sure you change the right ones lol, that carb should have 70/39 and 31/31.

Im using most of my 318 bracketry, i was using it all when I ran a federal (swapped to sag). All pulleys are from a 71 a/c car. Pics, dude, pics. You can always make brackets with tubes/rod ends or evem heavy duty alum turnbuckles.

Bummer. I shimmed the mounts up about 1/8" on this last 360, and made a little shield so #1 runner didnt cook the ps hose. Barely, barely clears. Dont forget to check your driveline angle if you go that route!

This. Learn it, live it, love it. Symptoms are classic ff.

Just need a compatible whip, which can very quite a bit between brands. I like spool guns, much more handy dandy for on the spot stuff than a Tig. Or buy a whip just for Al as mentioned above, and rollers for the drive unit.