Recent content by skokz

I was told it was a 65

Running poly 318 for sale. Complete minus the accessories. 68 318 la block for sale. Was bored .40 over can either be rebuilt stock or built from scratch. Has new crank, rods and stock pistons. No camshaft and heads are stock no work was done to them. SB 727 transmission worked when car...

Have a 1968 318 engine that's been bored .40 over stock compression pistons. Was planning on just doing stock rebuild. Has new crankshaft, new connecting rods (stock) and new pistons. Original main caps where oil pump bolts to is damaged have another set of main caps that go with engine...

I know it fits now. Already have it installed in car as of last weekend. Only stuff left to do is hook up exhaust, wiring, new ignition switch and lock cylinder. Replace a motor mount that broke while installing motor.

Do you have more pictures of your engine? Like the throttle linkage setup and bracket. Got it in last weekend and now trying to finish up the small stuff. Found a throttle bracket for a poly motor since didn't have one. Just trying to see how throttle cable and linkage for transmission...

Thanks. That's what wanted to hear. The motor already has alternator and brackets in place. So shouldn't have any issues with that. The power steering pump has brackets still attached to it hanging/tied to frame rail. I think it shouldn't be to hard to mount up to block. Car already has 2.5...

It's actually a 65 not a 62. The owner thought was a 62 so that's why had 62 in original post.

Let me clear some messages out of my inbox and I'll send you pm here in a few minutes.

Thanks for all the info. The poly motor is complete from oil pan to carb. It came with the original manifolds. Only thing I'll have to look into next is the flexplate and torque converter. I have the original flexplate and torque converter from the '68 but the poly doesn't have one. After...

Just went and looked at it. Fired right up. Another question what is the difference between the poly manifolds and manifolds that would be in the 68. Would the manifolds from the 68 work or better off modify the exhaust system on car to the manifolds on 65 block.

Since my fury doesn't have a motor in it and this poly 318 has just been rebuilt and running is why considering going this route.

Im not sure if this is in the right section. It is a c-body question but not a member on that forum. Signed up over there but cant post over there yet. Does anyone know if a 62 poly 318 will fit in a 68 fury that had a 318? From what I can see looks like the bellhousing are the same. The...

Looking for a set of main bearing caps for a 1968 318. Pm me price with shipping to 27529 NC. Thanks. I do know block will have to be line honed with different caps Then the original ones. Thanks.

Never had that problem with map moving before, give me a couple of days and ill see whats going on with the map.