Recent content by Torrance00

Hello I know this posting is a year old, but I ran into a problem with A 360 intake.. It is not stock Chrysler but a Wieand It will not fit because of the A\C pump. has anyone done this setup, any ideas? Will a stock Crysler intake work with the A\C pump Best

Thanks for that info.. I know there is another person looking for a vacuum diagram for the 74 318, it is funny that I found a diagram for a 73 and 75, why is it that we can never find info on the car we have!! hahaha So been up since 3:30 AM and while searching I found a diagram... for a Cal...

thanks for the input... I am really looking for the Factory location of the vacuum connection. It is a California car.. No black box anywhere automatic, air, power brakes It could the vacuum is taken off the small conister on the passenger side of the air cleaner? Thanks Best

I know this has been asked and answered too many times, but can someone please tell me where to connect the distributor vacuum line to! 74 318, dodge I have a vacuum line diagram, but for some reason the distributor line is not shown Thanks

dovercrossing, could you repost the image.. on my browser it is not opening up

thanks for the info on the backing plates. good Idea on interchanging those parts. does make it a little hard to adjust and yes the self adjuster sits just fine. My point about the valve stems is just that you can still buy American. and I hope they use better material then those made in...

Hi All My 74 swinger has sat for a long time, too long and the left rear drum locked up... yes I guess I set the brake.. anyway after getting it off, (no easy task). I cleaned everything, wire wheeled the drum and painted them with ceramic silver. (had a can on hand) but what is...

I would like to install new decals and or stickers inside the engine bay on my 1974 Dart Swinger. Can anyone provide a picture or pictures showing where they go.. I'm also doing the jack instruction, but mine is still in place so I know where that one is.. I have a 318, auto, air, washer...

Since I live here in Cal, thought I'd post and see if anyone has a local place to have the original car radio repaired And to see who knows what might be a direct replacement radio, (meaning tuning and sound knobs in the correct location.. Best

Hello Again Well I asked the question, I was given an answer. "Thank You" So I'll pass on this for others On the 74 Dart, other models might be the same you need to find that out To remove the radio, start by removing the clove box Next remove the radio knobs and using a 5\8 socket...

Hello All This is a "how to" for installing defroster vents in s 1974 Dodge Dart Swinger.. My vents are completely destroyed. I bought repo's from Dante's for about $54 a pair. To remove and install you will need to remove the clove box for the passenger side vent. and remove...

My friend has a 68 dart slant 6. He said the car was running rough, not idleing as before. So he did a pressure check on the fuel line between the pump and carb. He said it was barely 1 psi.. So he replaced the fuel pump and (I was there) the car was started and the pressure was a little over...

Any thoughts on mufflers for this basic setup. OEM exhaust manifold, probably go with a 2.25" pipe, (stock is 1.6"). How far back should the muffler be placed... right in front of the rear axle, further forward?

Guess your right.... thanks

Hello all I need to replace my exhaust system ... just old leaks, falling of car. but I want to stay with the original exhaust manifold for the time. Is there anyone who makes just the "exhaust pipe" for the 318 in an A body? I've been on summit, jegs, TTI, weldon, etc: and ouch on a few...