Recent content by wayne57

  1. W

    [SOLD] Duster Sheet Metal

    need the left side tail panel for a 73 or 74 duster. mine is rusted around the tail light opening.
  2. W

    [SOLD] 72 Duster parting out

    pm sent
  3. W

    73 Duster 340

    I'm just checking to see if anyone knows if my old 73 Duster 340 4 speed is still in existence. Vin # vs29h3b263358. Ordered when in the Netherlands and sold in Warner Robins Ga. Thanks Wayne57
  4. W

    An Emmy for Chop Cut Rebuild?

    Dan, Congratulations on the nomination. Always enjoyed the show.
  5. W

    Need this nylon bushing...

    The clutch shaft bushings should be the small size for the normal clutch or the large for the heavy duty clutch. Everyone seems to have those even Autozone and O'Reilys. It is the brake shaft bushings that have the 0.810 diameter size. Why no one will reproduce such a simple part I don't...
  6. W

    Need this nylon bushing...

    Good luck on finding this size bushing. I had the same problem and from my research it seems three different size bushings were made. One is smaller than the 0.810 and one size larger. I contacted several people who said they had this bushing but after buying and having it shipped it was always...
  7. W

    dash cluster duster dart demon

    pm sent. Wayne
  8. W

    74 duster wire harness

    Go to mymopar.com. Be advised it is not 100% correct as it does not include all of the seat belt/starter interlock diagrams. wayne57
  9. W

    lower control arms

    Where are you located?
  10. W

    lower control arms

    I need the lower control arms for a 74 duster with swaybar tabs if possible and a v8 k-member. Also need an automatic brake pedal assembly or just a good pair of pedal bushings, the .800 diameter size. Would like to get parts close to Memphis,Tn. if possible to help save on shipping...
  11. W

    brake pedal bushings

    Well still no luck on bushings. Brewers has the large and small, but none my size. smsmopar gave me another part number but the inner diameter is only 0.750 and my pin od is 0.810. Has anyone else had this problem or am I the only one who has had these bushings wear out with this size clevis...
  12. W

    Evaporator core

    Thanks Dan, I bought the evaporator off of ebay. Sure hope it fits. Wayne
  13. W

    brake pedal bushings

    Thanks Jamakin. Sent them an e-mail. Hope to get a reply. Wayne
  14. W

    brake pedal bushings

    The pin O.D is .810 and the brake pedal I.D is .870 +- .001. To use a smaller pin the brake pedal and the pedal support bracket would all have to have metal bushings made. I'm thinking about buying the large ones from Brewers, and tryiny to cut them down. Then use a heat gun to reshape.
Back
Top