what headers are these?

-
joshua dewitt

joshua dewitt

Well-Known Member
Joined
Jun 25, 2012
Messages
330
Reaction score
24
Location
tucson, az
i picked these up a while ago, was told they were on a 69 a body, small block , they slip appart, once i remove the rust with a torch, for fit, and #1 tube runs straight doen not back and over, any clue guys?
 

Attachments

  • IMG_0934.jpg
    60.1 KB · Views: 490
They kinda look like Hookers 1 3/4 tube header, but they arn't Hookers.
The tubes look small, 1 5/8?
 
Hooker does make a set of the smaller primary super comp headers designed for the 273. This could be them.
 
They look like they could be old Blackjack, or Appliance headers. I think the Appliance headers had a 4 bolt flange on the street hook up. I can't see it in the picture, so that's why I said they could be one or the other.
 
they were on a 69 baracuda with manual steering and a small block. just trying to see if anyone has seen these before? they are ceramic coated, and the outter tubes are a slip on fit design. the right side nis the normal a body header with i believe the back tube is slip fit as well.
 
look like 67' up a-body hooker super comps to me... i put a set on a buddies car a few years back.
 
Oh Yeah, I remember these! Bought a set in 1975 to put in my 1970 Dart. I think these headers are Kustom Tunnel Tubes. It took about a week to crush the low bend below the K frame to about half the original diameter.
 
They look close to the Hooker 5204's that I had on my Dart, but the only tube that is removable on my Hookers is the front one!
 
Demonracer said:
They look like they could be old Blackjack, or Appliance headers. I think the Appliance headers had a 4 bolt flange on the street hook up. I can't see it in the picture, so that's why I said they could be one or the other.
Click to expand...

That is what I was thinking. Man your showing your age!
 
You must log in or register to reply here.
-

Back
Top