Cam centerline

-
TheGrateRonzini

TheGrateRonzini

Well-Known Member
Joined
Oct 25, 2017
Messages
1,111
Reaction score
995
Location
Western New York
Anyone know the cam centerline for the Trick Flow Track Max hyd roller cam? Gonna go with straight up for now for clay purposes. Thanks
 
Not much info to go on. Big Block? Do you have the camshaft grind number? How about the cam card? I'm sure you could look it up by the part number if you have that.
 
Last edited:
image.jpg
 
It is a 108 LSA camshaft, to be installed 4 degrees advance, on a 104 ICL

Where it says "Advertised Duration:" 104/112", it should read "Lobe Centerline" 104 intake and 112 exhaust.

"Maximum Lift" 243/247, should read Duration @ .050" 243 intake, 247 exhaust

Someplace on there it probably says, "PRINTED IN CHINA"
 
TheGrateRonzini said:
Anyone know the cam centerline for the Trick Flow Track Max hyd roller cam? Gonna go with straight up for now for clay purposes. Thanks
Click to expand...

When in doubt just advance the cam 4 degrees from the LSA number. That works pretty well most of the time.
 
Thanks for the info. We couldn’t figure out why it wasn’t listed on the card and my friend suggested 104 wasn’t enough for the cam if that was what we were to go off of. Alas some help from FABO and we are good. Unfortunately I got the wrong rods. Found out today. It is the correct number on the box, but the crank end is sized for a BBC. Had to have been at the K1 place. Seems to be part number 007AU33676 in the box of 007AT33676.
 
You must log in or register to reply here.
-

Back
Top