When I rebuilt my suspension, I converted over to the bigger tie rod ends and sleeves. I measured the lengths of the old assemblies and pre-assembled the new parts to match. The car has been on a lift for a year and when I did a quick inspection before rolling it off, I noticed that the...
I'm looking for a driver's side lower control arm that will fit a 1970 Dart. It needs to be in a reasonable condition so I can rebuild it. Preferably without the sway bar tab.
Thank you,
I started rebuilding my lower control arms and got the bushings out to put Peter Bergman's delrin bushings in and this is what it found in the bushing bore...
It looks like a previous owner did not use the washer welding method and really messed up the bore both getting the old bushing out and...
Do those of you who have put the Ford 8.8 in, do you just run your wheels as lug centric on the back since it has a smaller diameter register? I'm putting the 8.8 in my car, but I'll also be running the LMR SVE Drift 18x9 wheels on all four corners for a Mustang so the wheels will fit fine on...
Does anyone have a set of Firm Feel 1.06 torsion bars that would fit a 1970 Dart Swinger with a slant six? I would also consider other brands of torsion bars greater than 1" diameter.
Thank you,
Casey
I'm about to machine a custom aluminum flywheel for my CD009 transmission swap and I am including a 36-1 trigger wheel pattern on the back side. I'm trying to figure out if the bolt pattern on the crank nose is oriented to a specific TDC event so I can place the trigger in an orientation that I...
I finally got my adapter plate for a CD009 6 speed manual transmission from a Nissan 350Z machined and did a preliminary fit check today. You can review the full project progression over at slantsix.org in the transmission section. I'm hoping to machine the flywheel this week.
I'm just starting to get into the intricacies of A Body suspension geometry, so I have been doing a lot of research on what the ideal geometry should be for handling performance. Is there a billet spindle available that corrects any geometry issues such as roll center, bump steering, camber...
I'm converting my 1970 Dart Swinger from auto to manual. I will be rigging up a hydraulic clutch setup to use with the CD009 6 speed from a Nissan 350Z. Is it possible to just add the clutch pedal to my current assembly, or do you have to swap in the entire manual pedal assembly?
Does anyone...
I'm looking for a windshield and rear window seal that removes the stainless trim around the windows. My trim is in decent shape, but I like the look of the black seal around the windows. Thanks.
Casey
I have a 1970 Swinger that I painted for a senior project in high school and I thought I wanted to keep the side trim pieces on to prevent door dings. But I have decided that I'd like to remove the trim while I'm doing some fender bender repair from an unfriendly encounter with ice and the...
I need the DRIVER'S side headlight bezel for a 1970 Dart Swinger. Preferably with no cracks. I'll consider a complete grille because my center section is damaged as well. Please contact me via [email protected]. Thank you.
Casey
hello, i was just wondering what in would take to put a newer 318 into my dart. could i used a 727 bolted up to it or would i need to put on a newer tranny as well? the idea of just slapping in a magnum and having 230hp is pretty appealing to me. i know i'll have to splice in the wiring harness...