Search results for query: *

Can anybody tell me what the best motor mounts to use in my dart my 475hp/436lb torque motor doesn't like stock mounts found some on classic industrys page called Mighty mounts that look like stock but not then I found morosos Solid steel mounts thought those might be to extreme have frame...

I have an HEI ignition that calls for no ballast and was wondering what would cause to much voltage my gauge reads 15- 15.5 volts any help would be appreciated thanks

Can anybody get me up to speed on how to tell the difference between an auto crank and a 4 speed crank . I have a 4speed A-833 In my 70 and I have always have had trouble gettin trans to slide all the way in to bell housing usually about3/4 -1in so I normally just put bolts in bellhousing...

Bought a hays street strip clutch kit for my 1970 Swinger and I'm having trouble getting it into reverse and 1st gear I talked to hays because I extended throw from 5 1/4 to 6in on pedal And have replaced every nylon washer clips internal shift lever ball and spring They tell me my pressure...

I have a 750 dP on my 360 we removed the choke flap To get the extra power not overly experienced with carbs but Learning so hears what I got the 360 has a large cam duration And makes about 475hp the carb primary jet are#69 and have A # 26 squirter the secondary jets are #80 with...

any opinions on these carbs thanks :angryfir::violent1:

can anybody point me in the right direction for diagram and rebuild info for mechanical secondary 750 double pumper thanks

I have a holley 750 on my 360 no choke flap At first start the car loads up until it warms up (150 deg) then it smooths out but still has a slight hesitation at first accceleration any thoughts thanks

I have a 1970 swinger 340 4 speed and old mopar man was right on the money.I changed my spread from 5 1/4 to 6in and the car shifts great not even the slightest grind going into reverse though getting the over the center spring out was a little tough it was worth the time. :supz:

can anybody tell me how to properly measure for backspacing thanks any replies

can anybody tell me what the biggest widest wheel and tire that will fit under rear well on my 70 swinger with springs in stock location i would prefer 15"and if sombody could help me determin backspacing thanks for replies

on my70 swinger i have a a-833 the trans shifts great but i have to push pedal almost to the floor to shift i have the general 1 1/4 play at top new rubber stop at top but i was wondering if this is as good as it gets or ami missing somthing thanks for help

Dose anybody know where I can find the correct washers to mount hood hinges on a 1970 swinger? Thanks for any replies.

need to heli coil #3 spark plug on my x head i was told this could be done while in car can anybody give me some thoughts thanks

im going nuts trying to match paint to my dart.I have had napa mix me three different spray cans.I started with go mango because that was the color I was told it was when i bought my love. Then I tried Hemi orange met and recently had them mix strait orange 999 still have not matched the...

talked to aar today said that 1970 dart hoods that bolt on have a small problem with form they said hood has small raise on side of hood witch could be fixed in a hours time wondering if anybody has bought a 1970 dart hood from them and have come accross this problem thanks for any and all replies

does anybody have the measurements for the pentastar fender emblem on a 1970 dart thanks