Search results for query: *

Got my camshaft today here's my numbers

Was that one of those older higher compression ratio motors. With 8.3 compression a good cam and headers. 6,000 safe RPM for an occasional or a frequent shift RPM

I'm pretty low budget so I bought a couple sets of headers. a lot of cutting and welding tack weld remove and replace tubes. my first there's a tri-yy. basically same thing for the second one except I couldn't find Big block mopars so I had to make my own flanges got a piece of half inches all I...

you're saying I should shift at 5,000. Max rpm So for the pipe Max program should I use like 4500 or 4800 for peak horsepower RPM

I hope to be under 3000 with roll cage... Streetcar yes but built for racing

521 close chamber with stock Pistons

That would probably be good that duration can take 8 in off my primaries

I guess that would be more of the advertised duration been a busy week

I just threw that number out there wasn't sure waiting for my cam grinder to send me my specs. Less duration shorter pipes. Higher RPMs shorter pipes

Yes ridiculously quick this thing will be... wondering what's the top RPMs for the 413, 440 so I can finish my primary header tube length

Wherever you point the steering wheel it will go. sticks to the road like it has super gorilla glue on the tires

413 8.3 compression 5 Speed manual trans 3.00 independent rear end 3000 lb Cam specs are an estimate The Max pipe software calls for 47.5 inch primary tubes for 5000 rpm peak horsepower. What is a good max shifting RPM for the 413 or 440.

I guess those make good strong motor mounts for big blocks They look pretty clean

Every time I go to a bigger motor I seem to get it pushed further into the cab and lower to the ground I have lots of room up front. 15" crank pulley to radiator.

What would be a good strong rubber mount for big block to hot rod frame.

It's easy to see it was blue painted. I know it's very well balanced I went up The mountain and down the other side from Lake Tahoe all 2 lane The motor never fell over once

And the motors even blue

I bought the 71 Datson in 1975. Been on and off the road ever since. In high school they said can't put that mopar in there they're too big. So the other day I was Kayaking across the lake. The engineer, legend kayak Builder Racer, Auto Racer says the 413 is heavy!!! I said I don't think so...

I've done a lot of things surprise I'm still alive Never did the crack don't like no cracks Ordered all new

Are you saying the a883 is the same transmission as transmission as the chevy TKS 600

He insisted on PayPal family and friend's payment and was really given me the rush to make payment

I may be mistaken but it just seemed a little weird. It was recommendation from a new member

I do like your crack better

I've decided to go at brand new 1. I'm not always safety 1st, or I wouldn't get out of bed But when it comes to taking my legs off I'd rather be safer on this one

It's for sale I only have the picture looks more like a crack than a casting mark

Does this look like a crack in the picture

I need a bellhousing flywheel clutch pressure plate. big block to TKO 600 chevy trans

How much for shipping to 95651

I'm having some trouble and I realized I didn't know how to count when I said 128 yes it is 130 I couldn't figure out why I couldn't find a flywheel