SnowDrifter
Well-Known Member
What would be a good strong rubber mount for big block to hot rod frame.
Best motor mount for a big to block hot rod
- Thread starter SnowDrifter
- Start date
-
I think your going to have to go full custom.
On the pass side you could invert a spool mount. On drivers side you have tons of room
Start bending up steel
On the pass side you could invert a spool mount. On drivers side you have tons of room
Start bending up steel
mopowers
Well-Known Member
For my 66 Dart, I cheated and just bought some weld-on bushings and just attached them to some stock big block engine mounts.
https://southsidemachineperformance...d-on-4-link-bar-end-w-poly-bushing-dom-tubing
Granted, the bushing is poly and not rubber, but you said it's a hotrod, didn't you? Here are a couple photos of what I did for ideas. You could easily make something similar with stock biscuit or spool mounts though. You just gotta get creative, grab some metal, and get busy.
https://southsidemachineperformance...d-on-4-link-bar-end-w-poly-bushing-dom-tubing
Granted, the bushing is poly and not rubber, but you said it's a hotrod, didn't you? Here are a couple photos of what I did for ideas. You could easily make something similar with stock biscuit or spool mounts though. You just gotta get creative, grab some metal, and get busy.
That's what I was thinking
Just curious, is there any frame left up front?
You can make anything work with spool mounts.
SnowDrifter
Well-Known Member
Every time I go to a bigger motor I seem to get it pushed further into the cab and lower to the ground I have lots of room up front. 15" crank pulley to radiator.
SnowDrifter
Well-Known Member
I guess those make good strong motor mounts for big blocks They look pretty clean
-
