Search results for query: *

Good afternoon, I am trying to identify where the ground location is for the trunk, for my rear lights etc. I followed the wiring diagram, but it simply shows a ground for the rear defrost motor. I don't believe I have rear defrost and if I do, it does not work, as none of my HVAC works. Can...

Good morning, I am trying to sort out an issue with my turn signal relay. I bought both the normal mechanical and the Heavy Duty one (Electric and for LED). I have both incandescent and LED 1157 bulbs to swap between. If I connect the pink multi-wire V shaped connector to the relay, and use the...

Good morning, Can anyone share any insight on how to remove the Stop Light Switch? I looked on YouTube and none of the older models are shown.I don't have brake lights, and with my test light I am getting ho on both terminals of the switch at all times. I am thinking that should bot be, and it...

Good morning, I have been battling issues with getting my MSD 6 AL back up. I bought a new box and was running fine for about 4 days. Yesterday, I was driving and felt a skip for a second. It happened twice, and I shrugged it off as maybe a carburetor blip. I got on the Interstate and before...

I am still struggling to get my electrical issue with my 71 Dart resolved. I changed my headers and had to remove the plugs and wires to access manifold. When I put back I accidentally mixed up the plug wires. I went through the flames out carb and starts with backfires. Finally figured out...

I am rebuilding my steering shaft and replacing my switch for the 3rd time this week. When I put the last one in, I checked the switch for constant, then turning to Assec, then on and crank. I check each wire at each key position for power, BEFORE putting column back together. I noticed a small...

Good afternoon. I wanted to kick this issue out to the field of more experienced folks than I. My Dart has had the following and running for over 2 years: 1. MSD 6AL Box 2. MSD Blaster Coil 3. MSD Distributor (8534 Billet HEI Mag trigger Mechanical Advance) 4. 318 engine I recently rebuilt by...

I have a Lokar with the braided stainless sleeve. When you pull the throttle and the cable moves, the braided sleeve bunches up. I was told by a mechanic that the sleeve should not bunch up and instead the cable should slide freely and not pull the outer covering. He thinks the cable is binding...

I have been looking for a Service Manual for my car an have typically used the Automotive Historical Library (www.wildaboutcars.com) to access the PDF of Service Manuals. Unfortunately, the Mopar section is very limited. Anyway, I have the screws out of the panel and the adjacent one that had...

Specs: 350 Rocket Motor 2 Barrel Carb Auto Trans Column Shift Factory A/C Non-Locking Rear Good: Very reliable and decent condition driver Re-sprayed and wet sanded smooth finish & shine New Top and Rail Seals New Carb New Battery 4 new tires Full tune up May 2013 Clean trunk All trim is there...