Search results for query: *

These are the pistons on my 71 360, motor was done about 20 plus yrs ago, trying to figure out if they are low compression or not, I have no receipts or info since I traded the build for a truck, any help?

Ok here goes, I think I did a stupid mistake, I got a set of j heads sometime back, I took out the valves and put new ones in, no machining or anything, it has always ticked lick a bad lifter no matter what I do, I have 273 adjustable rockers, i've tried new springs, 2 sets of pushrods, 2 sets...

anyone in the dfw area I can look at tail panel

need chrome for 71 demon, hood and fender extension chrome pieces, also drivers side chrome that runs the bottom of rocker panel, oh also need dash pad for 73 dart, thanks

any body not cut the fresh air holes in their hood? I am thinking about not doing this

ok here goes, 71 340 motor with j heads, edelbrock rpm cam, 273 adustable rockers, had engine running but had ticking noise, found 273 pushrods to long, installed new shorter pushrods, noise was still there but not as bad, pulled lifters and they are not any good, ran this engine for about an...

I know this isnt the b bodies forum, thought i would check anyway, i'm in need of a right rear quarter panel for a 1965 coronet 2dr or 4dr doesnt matter just need from rear of wheel well back

looking for a bracket that goes behind kickdown linkage, here is a picture i need the part that is just under the arrow

i have a 71 demon with the 3443977 radiator as far as i can tell this is a correct rad for this car . what shroud do i need and how does it mount? i see no mounting provisions on the back side of it.

i have a 1956 plymouth belvedere, here is my problem, has new shoes,wheel cylinders,hoses and master cylinder. the wheels lock up after driving awhile, i can open a line at m/c and relieve pressure. i have put a new mc and 2 reman m/c's on still same problem. any ideas?