Search results for query: *

Well I can't seem to find my 2002 mopar performance catalog. And I'm trying to remember the specs on part #5107548 camshaft. It was in the magnum engine section there was 3 cams shown for carb applications the 300hp the 380hp and then this cam. Any help is appreciated

OK I have made a few engine harnesses from ram trucks with obd2 ecm's and haven't had any problems. They start,run and shift as they should in older vehicles. Now I also have 2 of the mopar performance p5153734ab ecm's for the 380hp crate engine mpfi conversion kit. But can't get them to run...

I have mistakenly ordered to many of these pcm's! This is the pcm that is used with crate moto fuel injection kit with the 380hp cam and r/t heads the set up makes 425hp. the wiring for the pcm should be the same as a '99 ram/Dakota and will be way more forgiving and require less sensors...

Hello, I am currently looking for a 380hp crate motor cam for a build I'm working on. I really don't care if it is used as long as it is in usable condition, good lobes and journals etc....

Well yesterday I dissected my 1998 5.9l ram harness I've never done the obdII harness before but have done a few of the obdI harnesses running low on those but have 4 of the obdII harnesses. doesn't look that hard just a lot more wires!! So far from my notes his is what I came up with. Any...

Just looking for some timing input on my combination? 340 .030 over trw flat tops 185-190 psi compression test on all cyclinders magnum heads with undercut ss valves and cleaned up bowl and pushrod pinch mp 228/[email protected] camshaft air gap intake port and gasket matched to the...

Well I am getting ready to put new valves in a pair of magnum heads but can't remember what angle the valve seats are? I will have to pull my stones out and measure and maybe cut a custom stone for them. Thanks for any help

I am in the process of putting my 340 back together it had a rounded cam lobe. So going through the list of mopar performance cam shafts I chose #p4452761 all of the specs I found online stated a duration @.050 of 228/231 and a 110 centerline. I received the cam today and it didn't have a cam...

I would like to beg, borrow, buy a set of the mopar performance magnum head porting templates. Any help locating a set is much appreciated

For sale I have a 650 dp with eelectric choke. I had it on a built 383 years ago. Back then I took the carb and truck to a pro carb builder and had it tuned. The main body, throttle plate housing and butterflies were trued by him and a couple butterflies were replaced by him because the...

Up forsale I have a set of adjustable rockers and pushrods from a 273 pulled from a 1966 dart I also have a factory 4bbl intake for the same motor. I would like $200 plus shipping for all or would be interested in trading for a 750 cfm holley vacuum secondary carb maybe a 650 also open to offers...