Search results for query: *

THANK YOU, I will test later today and let y’all know how it goes. Cheers

I already have the ignition module grounded, would I have power to the coil if it wasn’t grounded correctly?

Ground the ignition module? Ground what to where? Thanks

All new coil, ballast, battery, ignition controll module, distributor, cap, rotor. Maybe the battery is to small? I went to auto parts store and baught the cheapest one for a stock 66 dart?

I recently purchased a 66 dart with a230 3 speed trans and 225 slant six. The previous owner had a small Block v8 with hei ignition, he pulled the v8, put a slant six in, then sold it to me with the v8 wiring still installed. I converted it to a electronic ignition kit for a slant six and now I...

Found a pair thanks everyone!!!!!

Yes this is what I need how do I purchase

I need both thanks though!

I need the set on the bottom

I have correct rubber mounts for a 66 but incorrect metal brackets, the metal brackets I’m looking for are not offset the the right like the later model ones. When facing them from the driver side quarter panel they do not have any bends like a “s” they go straight. With an automatic I doubt...

The turquoise pieces of metal are what I need , after 66 they have a slight bend in them wich puts the motor too far back in the engine bay so my z bar is no longer straight therefore I can’t disengage my clutch

looking for a early a body 63-66 slant six motor bracket the metal pieces that connect the engine to the rubber. For my 66 dart, thanks!! Located in east bay California

Thanks for the info AJ/FormS , iv been peg legging it for a while... :banghead: haha even though it's my daily I only put about 21 miles a week on it. when I get home I'm going to check the play on the gears and then the crosspin to see if it's already shot. But if worst case scenario is putting...

:cheers: good call, damn eight and three fourths!

Hello all, I daily my 73 scamp with a 318 with a 3 speed automatic and recently there has been a fairly loud metal clank noise when I put the car into reverse or abruptly let of the throttle while moving. I'm thinking maybe it could be a bad yolk, broken u joint, loose transmission mounts? It's...

Been here for a while reading and checking out projects , just wanted to say hello from Richmond CA. I drive a 73 scamp with a 318