Search results for query: *

I was planning on opening up the exhaust outlet on my stock manifold to help it breath a little better. What tool would probably work the best? I was thinking about a burr but in a drill or impact driver. Has anyone else used something else with decent success?

Does anyone recognize what this kick down linkage is off of? My dad had several Mopara and collected parts off other from the junkyard.

I'm working on hooking up a kickdown cable to a Stromberg WW carb. The car is a track roadster (build thread here) I'm building so that's why I'm using the kickdown cable versus the stock setup. Does this look like something that should work fine? The yellow piece will be a 1/2" wide (not to...

Long story short I have been looking into getting my first new truck, bought a 2022 Ram 1500 Warlock 5.7L in early September and started having issues at 400 total miles. The engine wouldn't idle on a cold start and would pop sputter and cut out. Dealer couldn't fix it, and the lemon law...

I have a bendix stromberg carb and the throttle lever has a 1/4" ball riveted to the throttle lever. Does anyone know where I can find the socket end to fit onto this ball for a throttle cable? Preferably one that has set screws to attach the end to a cable. Thanks Gene

Looking for another Holley 2280 to rebuild. Even if someone just has the base plate or throttle shaft I wouldn't mind trying that on mine whose shaft was wore out.

Has anyone ever made bushings for a Holley 2280 throttle shaft? I just got done rebuilding mine and can't get it to idle and adjusting the mixture screws doesn't help. I noticed gas leaking out of both sides of the throttle shaft once the car was off. Such a shame because the engine was way...

I was adjusting the timing and points dwell today and noticed my carb body is cracked and damp with fuel. Is this a common problem with Holley 1920s? I was planning to rebuild a holley 2280 to put on the 2 barrel intake I have. I also have a carter 2 bbl I picked up cheap to use as a core...

Looking for 2 slant six valve spring retainers. Using 2 valve springs for a friction shock project but can't find anywhere that sells them. Thanks Gene

I have the exhaust manifold where the choke stove is open to the exhaust gases and it's leaking where the choke thermostat attaches. Has anyone had any luck sealing it with high temp silicone? Any other options? I don't have any spare remeflex to use. I do have a later exhaust manifold that...

Hello Everybody, I've been a long time reader of this site and found a lot of help in the slant 6 forum and gotten a few parts from here as well. I appreciated the interest in my car so I thought i'd start a thread to show its progress. When I purchased the car the previous owner was going in...

I know it isn't an A-body but the engine is out of a 71 dart I believe and this site has been helpful as i've been reading through past threads. I will be cruising it around on the streets and running it at various vintage racing events in Pennsylvainya. Thanks to @Road/Rage for the valve cover...

Looking for a 1966-1969 slant six valve cover the one with the ribs and the 1" hole for the pcv and the fill tube for oil/breather. Hopefully one in better condition than the photo I posted haha

I received this testing report with an aftermarket alternator I purchased for a project. Just want to make sure i'm reading it right and figured someone on here would probably know. The graph shows the Amp output vs RPM, this is the rpm of the alternator not the engine correct? Since the graph...

Looking for a pair of 5x4.5 wheel spacers the kind with the studs in them like wheel adapters, 1" thick. Anyone have any they'd like to get rid of cheap. Trying to get some different wheels to work on a project. Thanks Gene

Looking for a stock fan for a slant six, I assume they are all the same. Thanks Gene