I have (2) factory axles for 8 3/4 with new green bearings installed. I ended up having Moser cut the housing down and purchased new ones instead. They are 30 spline and measure 28 9/16 from the back of the flange. New studs installed.
$250 plus the ride.
Need help: just installed a 8 3/4 housing i just had narrowed by Moser. Also bought new axles. I installed the new third member (4:10 spool).
Left side axle went in just fine- right won’t go in all the way to seat bearing. It does engage enough to turn opposite side wheel and driveshaft. Seems...
Does anyone have a part# or link for the larger front leaf spring bushing for a 66 Barracuda? I'm doing a rear end swap (7 1/4 to 8 3/4) & spring relocation. I have a set of springs but noticed one of the front bushings are missing. I believe these might be whats called super stock springs but...
Looking for the biggest set I can get squeezed in my 66 Barracuda. Thought maybe someone has been down this road. I recently replaced my factory rear end with a 8.75 SG and I'm wanting as much rubber as I can get. From what I can tell by measuring, it looks like I can get a Hoosier 28x11.5 in...
Looking to serpentine conversion on my 318, but it seems the kits that are available say they are strictly for the "newer" water pump with lower radiator hose on the passenger side. Mine is the older version which is on the drivers side. Anyone know if there is a kit that will work with my...
Looking for a shifter with reverse lock-out that will replace the non lock-out one on my 833 OD tranny. I'm not sure its possible to swap them out and use my existing linkage, if someone knows for sure I'd appreciate the feedback.
Slant 6 out of 1966 cuda with 98k miles, runs good. Comes with 3 speed tranny, Bell housing, column shifter, clutch, pressure plate, fork, bearing, linkage. Also have the 4 speed bell housing (+$45) Radiator (+$50)
47038 area.
Question: How is the stick removed? I'm looking to replace the longer angled one with a shorter straight version. I can see the two holes from above inside the car, but there isn't a bolt head or nut on either side. TIA
Looking for the correct small block bell housing for the 833 4speed (overdrive version). Didn’t know there was a difference in the outside dimensions and mine won’t fit into my regular 4 speed housing.
Looking for complete gas pedal and linkage for a V8 66 cuda - I do have parts for trade as well (original 225 S6 motor, 3sp tranny, radiator, bell housing, clutch).
New member & new project (replacing factory slant 6 with 383 BB.)
Looking for some up to date information from someone who has been through this that could share sources or part numbers they used for big block mounting & installation. Also needing V8 center link, and the bell housing for the 4...