Search results for query: *

Best in my books!! would buy again from them for sure!

How hard do some of these kits shift?

towards the bottom of article. http://www.allpar.com/mopar/transmissions/torqueflite-tom-hand.html

I was also wondering how can this be. I did some googling and sure enought it comes up on a number of troubleshooting sites as a test for stalling when 904 put into reverse. http://www.allpar.com/mopar/transmissions/torqueflite-tom-hand.html towards the bottom it referes to block rad...

THanks for the replys Called a buddy at a tranny shop and he suggested I bypass the rad cooler with a piece of rubber hose and try it in reverse again. So I take some rubber hose and try it in reverse and WHAM no more problem. I do not know the status of the rad prior to me owning the car ...

THanks for the replys regarding this in a previous thread! Called a buddy at a tranny shop and he suggested I bypass the rad cooler with a piece of rubber hose and try it in reverse again. So I take some rubber hose and try it in reverse and WHAM no more problem. I do not know the status of...

Thanks for your replys. I have the idle @780 as any lower it will stall in reverse. THe car had a fresh tune up this spring and has been running great. Did suffer a coil failure ( 1 month old) last weekend same time this trans problem started. Talked to a trans shop and he feels a pump seal may...

Need some Help, When I put the car in drive, the rpm drops from 780 to 630. When I go into reverse the rpm drops from 780 to 450 and the motor is really labouring. just started doing this, is the converter going out to lunch? 360 stock, 904 trans THanks

I am underneath the car taking some measurements for the 83/4 I have and expected rims I might need. 67 Dart I measure the existing 71/4 rear end(10 bolts) and here is what I have. leaf spring center to leaf spring center 43" flange to flange I have about 49" How can this be when most...

THanks for the info. The driveshaft is out of a dart. I will use my own.

Hello in A-Body world!!! I have a 67Dart. 360, 904, 7.25 rear end. I have a A-body 8.75 with a 489 case I am installing. Instead of the original driveshaft that I would have to cut, I have access to a driveshaft that came out of a 340 727 8.75 car. My question is, can I use the 340/727...

Hello, Can you tell me if I swap out the 7.25 rear end in the car now to the a-body 8.75 rear/ 489 case I have now, can I use the same driveshaft? 67 Dart 360, 904

Thanks for the responses. Rather than cut the driveshaft can I simply move back the rear end and center the wheel in the wheel opening? I have 360, 904. SS springs THanks

Thanks, same u-joints and mounting flanges?

I was lucky enought to source a 83/4 with a 489 center. I am going to put on a 67 Dart with that has a 71/4. Do I have to do anything with the orginal driveshaft. Is it a bolt up? Thanks

How do I adjust my 904 for shift points. It shifts way to early. it is also very hard to get it to kick down. thanks in advance!!