Search results for query: *

Did you try mrgusa.com he might make them.

I need a set of 1970 Roadrunnner etc. rocker panels anyone have any? pm me !!!!!!!!!!

I would assume manciini is getting them from somewhere like uscartool. From some of the guys I talked to not every floor is stamped exactly perfect. I used to work on the line and can understand how that might happen if you know what I mean. So just because they say you can hold the connector up...

65 valiant what did you end up doing? I looked at Manciini Racing ones and they wanted $189.00. I have a convertible and think I better tie mine in before something goes awry. Does anyone know if they are different because of the frame boxes for the covertible?

Autozone has ignition switch for under $20.00.

Does anyone know if the shrouds are different for ac and non ac cars on a 67 Barracuda? I see the top hose of the radiator mounts dead center on the non ac radiator and top hose mounts to pass. side on ac radiator. Therefore i'm assuming the shroud can only be used with the radiator it came with...

Anyone have a used original fan shroud for my 1967 Barracuda non ac 273cu. inch. It would be greatly appreciated and does not have to be nos. PM me with what you have.

I think i got a set but i cant look til Monday I'm going away for the weekend. I do have a lot of fastback stuff and will be going to the nats. Im not to far from you just Buffalo. Anything else? I have a 67 convert and would trade for parts.

I think your right they look like the 40 series from stockton. Maybe Ill bight the bullet and buy them.

Thanks 62bt409 but I need 15x6 with 4 1/4 backspacing.

I need the exact rims as pettybluedart has in this thread except with 4 1/4'' backspacing. Anyone?

If they are straight I will probably pick them up if not to far. How many miles from me are you?

15x6 right. How far from the border are you? Peace bridge, lewiston Queenston I don't care.

Wanted 15x6 cop car rims shipped to buffalo,new york?? Any one have them?? Two needed.

Wanted carter abs 625 carb. I really just need the top plate where the fuel line goes in. The housing is stripped on my rebuilt carb anyone have one?

Go get the police report and make copies. Then go get dmv driver abstract with her plate number that will tell you how many accidents and insurance changes should be 15 dollars. Do not call her or tip her off. Then contact her insurance company and let them deal with it. You already filled out...

bump

Does anyone have the harness that goes from the steering column to the floor shifter for sale? Let me know on this post or pm me.67-69 barracuda or maybe others.

In need of the shifter bar that connects the shaft that comes through the floor to the front of the transmission for a 727. Send me a pm if you have one.

Do you have any pics of what you need??

I need a 727 Tailshaft with the two bolt holes in it for the floor shift. Any one interested in parting with one PM me.

If you still need them let me know I think I have a few.

If you have an air grinder and a welder you can do it yourself. I just did mine and the cost was minimal but there was alot of time involved. I ordered the correct paint online from a spray can and repainted everything. If I can answer any questions email me [email protected]

I have a couple of sets of inner fenders. Some still connected to the frame rails and some that have been drilled out with a spot weld bit. I probably have too much to list. Here are some others: fastback rear window interior pieces hood