Search results for query: *

that's ok! thanks for your help. Bill

I got er done! I had the wire hooked up to starter relay for some (unknown reason) thanks for the help, Bill

Got er done ! I had the wire hooked to starter relay (for some reason) unknown! thanks for the help! Bill

I do not have a electric wire on my distribution block! where does the wire for it come from (engine harness)? maybe I have a wire hooked up wrong to starter relay!

if there is suppose to be a wire on the safety switch, where does it come from or should I say go to? I am not seeing any loose wires any where in engine compartment or under dash! would that wire have been part of the new engine harness I bought? if so may be I connected a wire up wrong

is the distribution block where the brake lines go to from master cyl. then go to front and back brakes, located below M.C and mounted to frame? if so I do not believe that I remember seeing a electric wire going to it, when I did the brake lines!

this is my park brake switch correct? but, I am not sure where is safety switch is?

my brake light on my dash is on! does any one know what sensor or sensors would cause this? my car came with out power brake! Front disc were installed before I got the car and I have installed Rear disc along with Power Brake Master Cylinder, PV and Booster! I already depressed the switch on...

I have found that there customer service "really sucks" but so far there products are fine! I guess the owner,Wayne, had both of his arms torn off in a motor cycle accident and put back on and his skull cracked open and brains exposed, but now has use of his arms but dealing with some memory...

why is that? if I might ask!

just thought I would show everyone the new unit that I bought from The Ram Man INC.! this is there latest version for A-bodies with proportioning valve right up front! I modified the bracket so that I could remove sensor and make assembly and disassembly much easyer!

No Kidding! I would have never guessed that! I know it is long, because it is all there, just cut in half and folded up! I thought that it might run some where along the K-member!

does anyone have a picture of how the front brake line runs across from drivers side to passenger side? mine is all bent up and cut in half. I have all the tool to make one up but I do not know how it was routed from one side to other! I could not find any pics in my service manual either.

ok! mine must be 73 & up then!

they did not have the large bolt pattern, did they?

these have the large bolt pattern and if they all used the same caliper and pads I do not have anything to worry about. Thanks for info!

ok thanks! I called Auto Value and they said that 1973 thru 1975 were all the same!

when I bought my 1970 Duster it came with these front disc brakes on it! But I do not know what they are off of, So can anyone tell me what they are off of? I am pretty sure that 1970 Dusters did not come with disc brakes and they do have a Chrysler emblem on them and some numbers in the picture.

I have disc brakes on the front and rear on my car now! my question is can I use my original master cylinder and if not what all do I need and who sells it? will I also need a different proportioning valve?