Search results for query: *

  1. R

    8.75 clean-up opinions

    Same here... I have had 3 places quote me $150 for blasting (or stripping) and powder coat here in Cincinnati. I haven't done it yet, and not sure if I will...
  2. R

    identifying what rear axel gears i have...

    Are looking to figure out the gear ratio, or the series/ring gear size (7 1/4, 8 3/4, 8 1/4)? It's probably a 7 1/4 in a slant 6 car, but post a picture to be sure...
  3. R

    8 3/4 vs 9" cost-wise

    I am building an 8 ¾ right now. Here is what I have in it so far… Real a-body housing - $200.00 Dr. Diff BBP axles w/ bearings - $300.00 742 with rebuild clutch SG and original 3.23 gears w/big yoke - $350.00 Shock plates and U bolts came with 742/3.23 deal- $0.00 Brake lines -...
  4. R

    Surface rust on gears

    Ok I am convinced... Thanks for the advise everyone
  5. R

    Surface rust on gears

    Good point on it sitting, but wouldn't the lube in the gear case keep it from rusting over? Would I need to change the lube any sooner?
  6. R

    Surface rust on gears

    I just bought a center section for my 8 ¾ build. It has a clutch sure grip, and it was rebuilt a while ago, but it has been sitting around uninstalled. As a result, it has developed a small/light amount of surface rust. It’s not much, and most is limited to the spline holes, the adjuster...
  7. R

    Rear gear question

    Pretty sure the pinion shaft diameter is what is different.... Ring and pinion set only fit one case and are not interchangale.
  8. R

    Rear gear advice

    Thanks all, I originally thought it was going to be a 3.23, but it turned out to be 3.55. Now that you mention it....What would be a good price for a for a complete non SG 3.55 a-body rear? I live in Cincinnati it location matters...
  9. R

    Rear gear advice

    Thanks... Any info on what RPM range I would be running at 65mph? Also what height tire would help change the ratio?
  10. R

    Rear gear advice

    Looking for advice on rear gear selection. I have a line on an open 8 3/4 rear with 3.55 gears for sale, but I am unsure if 3.55 is the right choice for me. I have a mostly stock 340 and I am currently running 215/70/14's (would like to go wider in the rear). I only drive it on the street and do...
  11. R

    UH OH!! Did this Hurt Anything???

    That is what I did when I overfilled after installing a trans cooler... just don't try it when the car is running or you will make a huge mess like I did :angry1: I like to think I have gotten smarter over the years...
Back
Top