Search results for query: *

Bump Offers? C

How about $250 and I will pay the shipping? I will also sell the parts separately. Thanks, C

I will take the overflow kit. Thanks, C

I have for sale most of an aftermarket a/c kit from http://www.nostalgicairparts.com Complete, this is about $600 for a sb Mopar. I have robbed it of the compressor, dryer, one brace and hoses. Everything else in the pics for $250. Located in middle GA, will help with shipping. These are...

What kind of leaf spring do you have on there? Never seen one like it. C

Thanks for taking the measurement, it is too deep. The one in my pic is one I purchased without getting the measurements first! I want to replace a 2 belt pulley from an '88 gran fury with a single. Thanks again, C

Too shallow, thanks for taking the measurements for me. C

Evening Prine, Could you take a measurement on the water pump pulley for me? Actually a couple. What is the diameter, and what is the depth as measured like in my pic? Thanks, C

Thanks for taking that measurement. It won't work for me. In fact, I have one just like it! C

Evening, I may be interested, can you tell me what the diameter is? Also, if you could measure the depth like I have in the attached pic would be helpful. Thanks, C

Evening, Would you take a couple measurements from the wp pulley for me? Diameter, plus depth as shown in my pic. Thanks, C

If 66gtx doesn't take it, please contact me! C

A good buddy has a 727 to sell. It came from a Dodge pick up, it was rebuilt several years ago by the best shop in Macon and has been stored since then. He don't want much, just doesn't need it any longer. PM me your cell phone and I'll put you in touch with him. Located in Middle GA...

PM sent, re: grill emblem. C

PM sent on single groove pulley. C

ptpt, I have an ac box from a '74 Duster if it is something you can use. Located in mid-Ga. C

Cliff, I posted the following message on a Pontiac list I am subscribed to: Evening folks, If you have any interest in an Edelbrock Performer Pontiac intake manifold, here is a link to one for sale: http://www.forabodiesonly.com/mopar/showthread.php?t=153667 The seller is a regular on a...

PM sent. C

Make that a K-7075. Your local auto supply may have it or be able to get it. C

Rob, What do you have to put it in? I thought you were going a different route with your Dart? If it doesn't sell for cash, maybe we can work something out... Kid, I don't know about the 833. I can look it over and see if it has other bolt holes though. C

Have the complete set up (less clutch rod) from a '72 Duster for sale. The good, includes pedal set up, 3 speed tranny, back up light harness, frame bracket & Z bar, bell housing, pressure plate, throw out bearing, clutch, drive shaft, interior floor hump, shift lever, bellhousing bolts and...

Mind if I link to this post? I will post a for sale ad and see if I can move anything. C

The rears are short. There is an intermediate, uncovered, cable that loops from one to the other and goes forward close to the transmission crossmember. C

I have a '72 Duster parts car, if it is the same cable. Shoot me a PM if you think it would work. C

PM sent

The link worked! I will print it out and plan on this upgrade. Many thanks, C

I would like to see the Mopar Muscle article. I have a cop car myself with the rear sway bar... Do you know what issue or how long ago it ran? Thanks, C