Search results for query: *

I move the back of the seat forward, I believe it was 2 inches. then I move the bottom seat drilled out the spot weld to the bracket move that an inch forward. Then I extended the big side panels were they screw onto the car out so that they would cover the wheel wells and look factory (that...

I cannot find my picture of the rear panels in.

yes 67 Barracuda Notchback rear glass is different and smaller

From what I’ve seen people do. They are pie cutting the top and adding a piece of their old quarter panel to get that gap closer

I think you have more holes than a 67 trunk would have. It looks to be a 67 but not sure what these hole are for?

The E Body rear trim clip works. A little wider but that does not effect anything

Very fixable. Drill out the spot welds and separate the headlight area. It will be wide open to fix. Then reweld the headlight area back in.

That could be. I know my 68 GTO has the most of the vin on the firewall. Ebodies same way

From what I hear from The department of motor vehicle a legal way is you have to sell the vin with the firewall. Not sure why that is considered a car. I am not in favor of this. I believe there was a Hemi Cuda or a 440-6 pack Cuda(can’t remember off the top of my head) where it was sold like...

AMD is screwing every dealer out there, No more deals. Thats why there is no more good deals on AMD panels.

I have 69 ones but I do not want to ship

AMD still make 67 ones that you can use

Early 71 came with go wings also. not just a one year only.

I used precision, I got mine to fit better than that but still a hair off in the corner. I kept working the rubber over and over. took a while. I did not used any sealer.

I thought the charcoal color meant satin

right, sill moldings are rocker moldings wasn’t thinking thanks

I have not found anyone that sells them separately. You have to buy the kit for the e body rear trim.

Do you have a picture of the special sill moldings?

I just have the hardware for the gills not the spares but I posted what you can use for the spares

Yes there is black strips from the factory. Nothing fancy. I have to relook at one I have here somewhere.

I also have NOS hardware for the cast gills I only have a couple sets left

Yes just pain rocker molding option. They do go in the same place on the rocker.

I still have the small pieces I cut down. I carry one with me at the swap meets shows Body color under the molding.

Yes same size just longer you can cut them down. I have done it.

The e body trunk molding clips work for the spares, they clip in correct just a little longer

There are 3 different spare lengths and part numbers 1 long spares with no gills 2 shorter spare that the front wheel opening molding goes all the way down with the gills 3 a little longer spare that the front wheel opening molding in cut short with the gills not sure why or there was a design...

This is a very cool option in 68 I have two sets of the chrome grills that need polishing that I will not be keeping. These are the front grills

The scoops were also offered on Dusters. I believe 1973 Duster twister had the scoops.

very cool!

Let me know. Because I do not need mine anymore, I sold the car years ago. These are harder to find.