Search results for query: *

OK, tomorrow I’m going to take the Teflon off and try it again. If nothing then, I’ll have someone test the sending unit. Thanks for all the advise.

There is Teflon on the new sending unit but a friend touched the plus side of the battery and the side of the sending unit with a test light and the light came on. He said the sending unit is grounded. Is he wrong? Is there a fuse that might cause the gauge not to work?

Yes. All other gauges work fine.

I have a 1973 Dodge Dart Sport 340. The only thing not working was the temperature gauge. I tested the gauge by grounding the push on plug and turned the key on. The gauge pinned to hot. Turned the key off and it went back down. I'm thinking that is easy, I need a new temperature gauge sending...

Can anyone tell me where I can purchase the repalcement in-dash tachometer sending unit board? Thanks, Al Barlow Maine

Sorry but not sure what FSM stands for?

Does the in-dash factory tach on the ‘66 Formula S have a sending unit? My tach is not working.

Ordered. Thanks everyone and Merry Christmas. Al in Maine

Thanks, I think I will use it with Year One if you have it. I think the one I need is the part Number: HU226A Engine/Forward light harness for 1968 Valiant and Dart slant-6 models, and Dart 383 models.

This says for 1967 Barracuda. Will it also fit my 68 383 Dart? I'm also not sure about the other areas that have to be updated. I think I have the original points distributor.

I have been 4- years restoring a 1968 383 Dart GTS 4-speed car. Now when I'm getting close to the end, my body man says I need an engine compartment wiring harness. Can anyone help? Even if it needs work I still might be able to use it. Possibly other years and other models will also work...

Anyone have a photo of the felt?

The distributor is a 2875356 that is correct for a 1968 383ci 4bbl and manual transmission. No flip-up oil cap on the side. No felt pad inside the shaft under the rotor. Just a nylon bushing and metal washer on the bottom with a pin. here are a couple of photos.

No suggestions?

I picked up the correct distributor for my Dart. I disassembled it, cleaned it and am ready to put it back together. I am not sure what type of grease/oil I should put on the long shaft. Will white lithium grease work? I am going to install the Pertronix in it so I am not worrying about the top...

Dartman1969, Thanks for the information. I will do that.

67Dart273, Thanks for the help on the console tach hookup and the manual. Does anyone have an answer to my 2nd question? Question #2: I need the engine and front lights electrical harness to connect to my original dash harness. I have seen an ad on eBay that states: 1968 or 1969 A-Body...

Can anyone out there help me with these two questions. I am restoring a 1968 Dodge Dart GTS 383, 4-speed car. Question #1: I purchased the console tach that I needed as it was an option on my car. Can anyone tell me what/where each wirs goes? Question #2: I need the engine and front...