Search results for query: *

Yes, take-off definitely gonna be soft but not hot rodding/racing at all. Really just going to local car shows but some are a little farther away and require longer/freeway drives. Few more engine/tranny specs I should have included earlier are listed below. 360 mag - 30 over 370hp @ 5300rpm...

Yes Oldmanmopar, current stall of TC is my biggest concern here. So in your opinion, what's 'too high' of a ratio? I do have a aux tranny cooler and a trans temp gauge to keep an eye on it, but don't wanna be creating more problems than it's worth. Also have seen a 3.08 (harder to find) and...

Definitely think 2.94 is gonna work best for my application now. Again, just want to make sure this swap is going to be as simple as just changing out ring/pinion, new gasket/fluid, etc without having to modify anything else (new TC with different stall, modifying shift linkage, etc).

Guys, newbie here. Looking for some advice on a potential rear end change. Been running a 3.91-SG last few years (741 case) but end up driving car much more on the highway than originally planned. Considering going to a 2.94 (maybe 2.76) and have a lead on a NOS ring/pinion set. Realize this...

Wish I would have read this thread a couple weeks ago! Just finished installing a new B&M cooler and -6AN lines/fittings but used the nitrile braided stainless from Jegs, not the PTFE stainless hose. Tried to find some pressure and/or temp ratings on Jegs' website for the stuff I bought but...

bobscuda67, Could you please post a close up pic of your throttle/kickdown linkage setup? I'm using the OEM '67 linkage and throttle cable with a new eddy 650. I was able to find a pic of how/where to attach my thottle cable, but haven't seen how/where to connect my kickdown linkage? I've...

73AbodEE, Can you please shoot a pic of your setup from the top that shows how your throttle cable is connected? I plan on adding TrailBeast's spring myself, but am confused about where to connect my throttle cable? I have a new eddy carb with the mopar adapter (#1481) already installed. If...

What kind of sleeve did you put over the black braided stainless? I'm assuming it's some sort of heat shield. I'm planning to do this mod myself soon (switching from steel hard lines to braided stainless for the cooler lines), but plan to run the lines completely away from the headers so...