Search results for query: *

What kind of variation between ports is acceptable?

I have CC'ed plenty of chambers but neverCC'ed a port. How is it done?

Anyone have a pic of the old Hooker super comp 5322 W2 small block 2" A body header installed in an A body? I'm just wondering how big the hole for the tube that goes thru the fender-well has to be.

Iron or aluminum head?

Thanks. Im gonna have to put some test springs on it and check it out.

I have a set of W2 810 casting heads that i am planning on using on a SBM build. When i bought them i also got 2 sets 1.5 ratio rocker arms and shafts. I was looking over the rockers (one iron set, one Mopar performance blue rollers) and noticed the stands and the shafts are offset drilled...

LOL both!!

GO get them ENDORPHINS! I work out three times a week at Orange Theory Fitness... I love it. Sure changed this old mans life.

I have pocket ported a few Mopar heads with templates, but never have had them on a flow bench. I have done a lot of two stroke reed valve motors way back and i can picture in my mind what your saying.

Dang! This is an awesome thread. I was really debating about using cast iron 80's technology open chamber heads....

Thanks guys, thats a lot of good info. I do want to run pump swill.... i will cross that bridge when it comes to it. I know cam selection will have something to do with that.

LOl i just noticed i spelled casting wrong!! Duh. Anyway what is CSA?

Thanks for all the info. I have considered Trick Flow heads... i have a strip Strip Dominator. I have everything to do the W/2 heads but the headers... I have a 340 block also...

I do plan on stroking it. Considered a 426 kit.. don't know if the heads will support that. Anyway i was trying to get some quench from the setup. i have milled a 456 BB mopar head casting to a closed chamber and not had problems with it. i did use stock pistons with it.

Question for Pittsburghracer. Are you tubing the head bolt and push rod hole just so when you hit copper you know to stop cutting?

Thanks!

They look thin around some of the cooling holes. I cc'ed them a while back and it seemed that they had not been cut. Decking the block makes since, dollar wise much cheaper than pistons. How much should the pistons stick out? If i remember correctly the open area was about .070"-.075" deep. If...

Its cold and i'm thinking of the 360 i may build in the spring. Its flat top piston .005 in the hole and .030 over. I have a set of ported W-2 heads and would like to know how much i can safely mill them. Anyone with experience? I don't believe they have ever been milled on the chamber side.