Search results for query: *

http://mobile.craigslist.org/pts/1778201467.\html Just down the ways from me if I can make any money off of this or offer him little money for just a few pieces would any of it be worth it? I don't have enough money to build the 340 so I would'nt have a use exept to resell it. Thanks for any...

I have a 2 barrely intake off of a 70's model 318 that is higher up than others and also has a edelbrock design sort of a x for the tunners but it is wide open on the inside maybe this was a marine intake? I know it hauled but in the valiant it was in. I am sure its not "high performance" but I...

What is the main difference between the motor mount on the 360 swap? this is in a 72 d100 with a 904 I thought I had got the right motor mount but it wont seem to bolt up something no matter what I do is offset or in a bind. Any help would be appreciated!

I recently got a 318 .40 over smoking it's butt off I bieleve the oil rings are shot because it has good compression anyway. I am honing it out new rings and I took the 302 heads and ported and polished the intake and exhaust sides and port matched them I am also running and comp cam 260h cam...

Hey just wondering guys is there anyway to know your compresison without doing al kinds of machine work? I was told you can do it with just a compression tester. If so can someone explain to me the formula for doing it. Thanks, Kevin

I just swapped 318's in a truck and the only difference was that the new motor had the 90 degree oil adapter on it and wouldn't clear the headers so I swapped them out and I didn't see a gasket or rtv so I just bolted it on and it obviously doesn't seal at all am I supposed to put a gasket on...

I got a 360 with eagle crank pistons and rods out of a 73 cuda my question is when I took the car oil pan off to inspect it all looked good when I put the truck oil pan for my 360 swap when I was bolting down the pan the edges of the tray were rubbing I went ahead and bolted it down (foced it a...

I have a 318 with a rv cam headers an awesome LD4B intake and a 600 eddie carb. It has rebuilt 318 heads with stiffer valve springs. The motor screams all the way to almost 7000 if I hold it (I know its not good on it) But, at very low rpm it laggs until about 2500 3000 I think its gettin to...