Search results for query: *

I have wanted to do a HEI conversion for my Dart for a while. But since I dont like the look of the GM HEI and had a bad Mopar ECU lying, I came to the conclusion to combine them both after reading a post where trailbeast done the same. I used a heat gun and screwdriver to remove the black...

Hey FABO this thread will show my installation on the EZ wiring harness. It has been much preparation to just getting started have read a ton of threads. Then I have carefully looked at diagrams and looked at the original harness to get hold of how all things works and goes together. Bought...

Today when I removed the dashboard I managed to break of two pins. :oops: And I wonder if it can be repaired? If so have anyone of you any ideas? Would greatly appreciate some input how to repair them. Have one idea to solder the pins back and secure them like this.

I'm going to rewire the whole wiring harness on my 73 Swinger. And I can't find how the wires go to the light mounted on the column in the factory wiring diagram. What activates the light? And what's the task for the switch mounted under the ignition lock? I know that when you put the key in the...

I will replace the wiring from the alternator to the Amp gauge and so on. I don't going to bypass the Amp gauge because it is working and shows no melting behind the gauge. I wonder if I could use the factory fusible link and solder it on the new 8 gauge wire i will use. Will this work or must I...

My ignition coil gets hot when the motor is running and I wonder what is wrong. The ballast is cracked so can it be that who cause the coil to get hot?

I have electronic ignition on my 1973 Dart with a 318 and I was wondering how I can adjust the pick up coil. What I found is that the gap between the pick up and reluctor should be 0.08 "- 0.10". Are the information right i've got?