Search results for query: *

It has been monsooning here so not much trouble shooting has been done...but if I can avoid heading off in the wrong direction , it would be a help. 360 engine. Clean fuel filter. New carb etc..all about 2K kms old..between 1/2 and 1/4 tank gas. Coming into our subdivision..a slight...

Well the big came to start the engine...when we added the water, it started to pour out over the floor. With a quick inspection, we seem to have lost 2 frost plugs when it was stored outside last winter. We checked with the company that did a mechanical break in and they don't all water. Very...

I am selling a "stock" 360 cam shaft. That is all I know about it. the PO bought a different cam and swapped out the "stock" one. How can I tell what this cam is...the engine was a quasi crate...the PO bought it as a rebuilt motor.. Thanks Ian.

I have mopar performance valve covers. I have a breather on one side and a pcv in the other..oddly enough, these covers came without baffles.. buddy today, tells me that I cannot run them w/o baffles..that the pcv will pump oil into the carb... sounds a bit odd to me.. anyone with experience...

I found 2 numbers....I am guessing aug '79 but that may be too easy. The 2 numbers are: 8-79-79 and 4179930-860-8 Thanks for your help.. ian.

It is becoming increasingly more difficult to re assemble units when I have no idea how they should look assembled.... Google images has been as much help as the service manual. Does anyone have pictures of their 360 with emphasis on how the ancillaries are attached and what goes into the many...

Hard to find a straight answer on the internet or here on how much and where.. I have a rebuilt 360...no real info on it except for it's cam. I have an a727 and an performance econ torque converter pus a flex plate. The 727 has been rebuilt and the torque converter is new. None of this has...

folks, Doin' the usual swap from /6 to 360...was going to use shumacher but I say these on e-pay..ant good ? Pic is for a 34..360 lited further down.. ian. http://cgi.ebay.ca/Motor-Mounts-2-Plymouth-Duster-5-6-1970-73-340-cid-/250616735838?pt=Motors_Car_Truck_Parts_Accessories&hash=item3a59ebe85e

Folks, Summer is coming fast and my kids are keen. I have been fretting over our crate 360. I know it has been sitting for over 2 years and all I didn't want to do was to shoe horn the engine in and have it not work so I have been looking at building a engine stand..even bought a good set of...

Did a search and came up blank..I would have though this had been beaten to death. I just finished a resto mag that stated that our new engine oil is very bad for our classic cars because there isn't enough lube for the tappets. The suggest a good quality , non synthetic, with a 1/3 of a can...

Hi, Not sure if I am in the right spot but I am looking for the plans to construct an engine / transmission / radiator holder so I can start/run my new engine before I put it into the car.. I have seen this puppy for sale but the vendors want $$$$$$$$$$$$$$$. I have friends that are handy...