Search results for query: *

What grease should I use on the steering linkage on my 65 Barracuda

If I adjust the torsion bars to lower the front end by 1" on my 65 Barracuda do I need to get the front end re aligned?

I have a 1965 Barracuda that I'm replacing the wheel bearings on. I've never done this before but from what I've found is there should be a wheel bearing race pressed in then the bearing rides in the race and is captured in place by the seal. I removed my hubs and this what I found on both of...

Are the boots for the torsion bars really necessary? I've read ways to install them but wondering how important they are. I only drive my car about 2000 miles a year

I'm going to trailer my 1965 Barracuda from Atlanta to Youngstown Ohio on a Penske trailer. My question is what is the inside dimension from tire side wall to side wall. Thanks in advance. Bill

Going to replace my idler arm and tie rod ends on my 65 Barracuda. Has anyone used A-Resto-Parts and if so would you buy them again? Thanks Bill

Thinking of rebuilding the front end on my 65 Barracuda. How hard is it to do and do I need any special tools? Thanks Bill

Changed from power to manual steering on my 65 Barracuda with no problems thanks to all the very good info here. thanks again Bill

Going from power to manual steering. Have removed the role pin and drilled out the other small pin on the manual steering box coupler. Is there a certain way to get the steering coupler off the shaft of the manual steering box. Thanks in advance. Bill