Search results for query: *

I have been trying to fix a problem of the brake light switch turning on the front right and rear left parking and brake lights. I replaced all parking and brake lights with LEDs and am using United Pacific 90650 flashers with the polarity reversed. I also installed a new turn signal switch...

I just finally finished installing a 8-pin Accel GM hei and am having an issue with a weak spark. I have checked for a good ground the module and the motor, and the module has 12V supplied to it. The C terminal is connected to negative side of a MSD 8207 coil and the tach. Maybe defective...

I recently picked up a trunk light setup and I am trying to figure where the light mounts. Just not finding any info. THANKS

I am going to ditch the MSD 6200 on my Barracuda for the GM 8 pin hei. @TrailBeast offered a kit at one time for this conversion. From what I have found on the internet about his conversion vs. the one on the Slant Six site is the relay. I already have the heavier gauge wires for the MSD box...

I have been searching the FABO site along with any place else I can think of for the right angle #10 stud connectors used on Mopar water temp, fuel, and brake warning senders. All of the ones I have found are for Gm or Fords and use a#8 stud. anyone have any ideas on a supplier? Or is it...

I am in the process instilling the windshield wiper assembly in my '67 barracuda and while testing the speed and park functions I discovered that it parks in the up or vertical position. The wiper motor is a newer '73 b-body that has been re-clocked to the right position for an a-body unit and...

I have a "67 Barracuda and the original Wiper motor is toast. After reading a number of post here on FABO about re-clocking wiper motors, I bought a wiper motor that's for a B-body and rebuilt. The problem is the 3-speed crank arms have changed thru the years and the '67 arm has a larger hole...

I have be reading a number of threads related to alternator upgrades. The Mad Electronics method of eliminating the amp guage looks good eliminates the guage, but I really don't want to drill the bulkhead connector and convert my amp guage to a volt guage. My question is, why can't I replicate...

I found this wiper motor while searching threads about wiper motor interchanges. Has anyone bought one and how well does it work, or is it junk. Napa, Summit, Oreill's and Amazon sells them. Some links below. https://www.napaonline.com/en/p/RWM49352 Cardone Remanufactured Windshield Wiper Motors...