Search results for query: *

I have a stock 01 5.9 magnum in a 71 dart. 340 hp manifolds, 727, and an 8 3/4 with 3:55 gears. Street only, I do highway drive occasionally at around300 rpms. I am looking for a good tight street converter, any suggestions?

Has anyone had experience with a Hughes 24-30 converter. I have recently acquired one, and was going to install it in my dart.

Have an 8 3/4 suregrip makes no noise under acceleration, when i let off of the accelerator it makes a whining bearing sound. I am trying to pin point the area, wheel bearings look fine, could it be a differential bearing? How hard is this to replace?

My current rear end housing is from a 65 B-body. If I were to narrow the rear-end to stock A body specs, will the current b body axles work in the narrowed housing? I will be taking of just over an inch on each side.

While doing exhaust on my car I happened to look at the torque converter and noticed the counterweights were missing. They were either removed, or fell off, I am not sure. I would like to find a set of them to replace the missing ones. They are the 2 rectangle shaped weights, there is still an...

I know that there are different size cups for U joints. Is there also different length U joints? I mean the distance across the U joint, I am trying to install a new U joint on an 8 3/4 and the cups are 1/4" from the edge of the yoke. This doesn't seem right. Maybe someone here can help me...

I have been trying to remove an axle from an 8 3/4 chrysler for the past few days, and it wont budge. I have all five bolts out, I reversed the hub and tried to use as a slide hammer, it still wont move. Does anyone here have any suggestions or tricks that would help in this situation. I have...