Search results for query: *

I clear coated my aluminum manifold with aerosol clear spray. Now it is turning yellow. I would like to paint mopar engine red color. How do I prep intake for painting without removing from engine. It was very difficult to install. The intake is edelbrock airgap on 360 in 66 barracuda...

My 66 Barracuda with 360 was running a little bad so I decided to pull the plugs and see what was going on. All plugs (autolite 65) looked good except #3. It was oil foulded. Checked plug for resistance, was OK. Checked spark plug wire for resistance,OK. What do I check to find problem? :???:

Does anyone have the specs for the vacuum advance canister for this MSD 8388 distr(ready to run 273-360). Looking for hg to start advance and what is full advance spec deg/hg when all in?

Looking to identify a damper. It looks like a 360 damper for cast crank. The only number on it is 50417. Looking for what year and vehicle it was installed on. Thanks

On a 318/360 engine are the bottom 2 bolts of the water pump wet if you remove them? I need to install old style timing tab that uses these 2 bolts to mount plate? Thanks

I'm trying to id a Damper. The only numbers on it are 50417. It looks like a 360 damper from it's design. Anyone have info on this damper( year, part#,casting#)? Thanks

When would you change oil & filter after winter storage in the Northeast. Before or after startup. It's a 360 that been in storage and last started in mid Nov. Unheated garage. Thanks 8)

I need to install Crane adjustable rocker arms on my 360. Which method do you find the best for adjusting rocker arms. Some say use Mopar adjustment chart, others say adjust E,I at firing order. Ex. TDC adjust #1 E and I, rotate 90deg. adjust next I and E of firing order. Which do you find...

Just bought a set of Crane Gold adjustable rockers(used) for my LA 360 with Comp hydraulic cam. How do you set-up and adjust these rocker arms. Never did this before, so be specific.8)

I noticed on MRL Performance website, that they do not recommend the edelbrock Air Gap manifold for mopar small block. They say the casting is off when compared to intake gaskets. I know when I installed mine, I had a difficult time lining up the bolts. I did not compare the intake to the...

What length pushrods are you using on 360 with stock non-adjustable valve train and hydraylic cam. When I used 7.50" there was no pre-load. I found longer 7.520 and used them, but the engine still ticks because the preload is incorrect. One of my engine books, say that 7.534 pushrods are used on...

Does it matter if the distributor intermeadiate shaft is not lined up correctly in the engine? ( gear slot in line with front left of intake at TDC#1). Thanks

What brand and number spark plugs are you running with 360? Thanks 8)

Hi, I have a 360 in 66 Cuda. The engine specs are: cam: 280H magnum(comp) air gap intake 3310 stock Holley 4160 72front jets plate rear stock 587 heads(1.88/1.60), speed-pro pistons 9.3 cr...

The engine will be idling OK, then starts shaking very badly. Give it some gas and it idles ok again. When it is shaking the vacuum gauge is pretty steady. It's a 66 Cuda with 360. Vacuum advance is not connected. Comp 280H magnum cam, air gap with 3310 750 Holley. Vacuum is 10" in gear. MP...

What's can I expect to pay for a 71 360 shortblock??:glasses8: