Search results for query: *

Looking for help before I pull the tranny pan off. I replaced the o-ring at the end of the shifter cable and also the transmission pan gasket on my 904 to cure leak issues. Filled it with fluid, found no leaks, then went to start it. Starter would not make a sound. I figure it had to do with...

Same engine, same 904 transmission, except it is rebuilt, original flexplate, new Hughes converter. Transmission is bolted in and now I need to slide the torque converter slightly forward to meet the flexplate to bolt it up. I need to slide it 3/16" to meet the flexplate. (I measured it by...

In talking with a transmission shop, the likely cause that my car will not move is that I damaged the front trans pump while trying to install the new motor. They guess it will run me about $400 to replace the pump and other gaskets and seals. My question is this: I've never torn down an...

I've been dreading this job...pulling my transmission. I need to check out the torque converter. This new Hughes won't make the go move and I'm ready to put the original back in, although I'm going to carefully check them both out. I put the new converter in when I had the motor out. Rather...

Fixed the oil leak in my new engine (273 2bbl w/A904 push button) and broke it in Saturday, ran it for 30 minutes. I timed it & set the idle. Car sounds good! I put the car into gear. NADA!! Doesn't want to budge. I noticed the transmission was a little over a quart low, I added fluid...

Before I drop my new motor in, my manual suggests replacing the front pump seal. It was not leaking before. I'm generally one to believe if it ain't broke, don"t fix it. But its probably the original seal ('64 Barracuda) and nows a good time. Does this seal pop out from the front, or do I...