Search results for query: *

I know this as been asked already and I've read all the responses, but I just need confirmation to go along with what I think I need to do next... On my 360 build, I installed a new brass bushing and went to install the oil pump drive shaft. It didn't drop in, so I gave a few taps with a...

Anybody have any pointers on what will make the install smoother? I've already read great things about the hardware and install itself, but I'm wondering if there's any tips that aren't listed on the accompanying paperwork. Thanks!

So I bought a freeze plug kit from Summit for my 360 that's getting built and I realized that the welch plug (The dish shaped one, at the back of the camshaft) that came with the kit has gone awol. After 2 hours of tearing the garage apart looking for it, I have run out of options. The local...

As I was assembling the bottom end of my 360 last Saturday, and my cousin comes over and starts pitchin a fit about using white lithium grease to assemble the lower end, (Mains and rod bearings). Especially about putting the stuff on both sides of the bearing during install inside and out. I've...

360LA Block, .060" Over, Magnum heads Looking to build a respectable street motor, good for mostly cruising and the occasional stop light jump. Camshaft Recommendations? I was leaning towards Lunati's Voodoo, but I thought I'd get some feedback. Also, doing the LA to Magnum Head...