Search results for query: *

Talking with some people about a 318 with an E58 360 cam in it. They claim it will kill the low end torque? My dad used to put the E58 cam in all his 318's because he liked the slight lope at idle. Never thought about it killing the low end?

I am guessing it has something to do with vacuum? The car is a stock 318 2bbl and it idles fine until you touch the brakes. Then it idles rough until you let off the brakes. We thought it might have been in the power brake booster, change that it still did it. Put the original booster back...

Anyone know the correct part number for a 71 Dart 318 2bbl carb?

Has anyone done a comparison dyno between these heads? I am still reading up on info for a 360( possible 408 ) build and was wondering about the pros/cons of using one vs. the other. I know the Eddy heads probably weigh less but was wondering if the the LA-X heads might be the better bang for...

It is time to make up my mind on the motor for my project. I have a 340 block and a 360 block. The car will not be a strip car, just a cruise night and Sunday driver. The Duster is setup for an automatic and will not have power brakes or A/C. I will run 93 or better gas all the time. I would...

Does anyone have a diagram of a Carter BBD-2425 carb? The pic was taken as we were pulling the carb off!! That is why it is not bolted down! :)

Sorry if this is in the wrong forum...... I am needing a some good pics of the engine compartment (and firewaall area) on 70-72 Darts. I am looking for good pics that will show the routing of vacuum lines and A/C lines. I was doing a last check on my Dart before I DRIVE it for the...

As many of you know I have been having serious issues getting my 318 to seal. It kept leaking around the head gaskets no matter what. So we decided to start over from scratch. Anyway with the help of a local Mopar man (and board member) I finally picked up a 360 block. So I am looking for...

Anyone bought one of the 360 short blocks that's advertised in the Mopar mags? Which company did you get yours (or would you buy from)? My idea is to go with a 9.5:1 pre-magnum short block, Edelbrock heads (right out the box), and a single plane M1. Nothing fancy just enough to rotate the...

Okay some of you might recall that I posted some pics of the 318 back in my Dart project. However after finding out that we had a cracked head the motor was removed again. :( Well that was over a month ago. Not to mention 4 sets of heads later I am still no closer to having the motor back in...

Do 1979 318 heads use the same head gasket as the 1971 heads?? Or are they different? When my Dad built the 71 motor for the Dart he used a gasket kit for a 1971. The head gasket was leaking on the outside (not into the cylinder) and dripping out the side of the block. So the motor is back...

Okay the machine shop just called. :( My 318 cylinders range from .012 to .015 wear. So they suggest boring the block .030 over and using 8.5:1 flat top pistons. They have the pistons in stock and the boring and pistons will add $320. So should I use their pistons ($140) or should I find...